Re: Pegasos OHCI bug (was Re: PROBLEM: memory corrupting bug,

[pacman]

Segher Boessenkool writes:
> 
> > So is it wrong to leave the host controller enabled when the OS is booted?
> 
> Yes.  Or, rather, there should be some way for the client to turn off
> all dma and interrupt activity; if the client closes the ihandles in
> "/chosen", and perhaps calls "quiesce", that should be enough.

Sounds good to me, I only wish someone had written down what "quiesce" means.

> >
> > Almost all of my devices are under that PCI node. What will I prove by
> > disabling them?
> 
> You should put it after "load", and before "go".
> 
> It should give you a working system; it's a sledgehammer workaround.

I can do it a little more gracefully than that. This works to deactivate the
problem devices manually:

  1 lbflip 80000000 8 + rl!
  1 lbflip 80001000 8 + rl!

where 80000000 and 80001000 have been obtained from
/pci@80000000/usb@5/assigned-addresses and
/pci@80000000/usb@5,1/assigned-addresses; 8 is the offset of the
HcCommandStatus register; and the 1 bit is HostControllerReset (HCR).

Now I'm just trying to find the more correct way of doing it, without
hardcoded addresses. That'll be something like this:

  search the device tree for OHCI nodes
  for each OHCI node
    get assigned-addresses
    map-in
    set HCR
    wait for acknowledgement
    map-out

which can be done any time before the quiesce call, since that marks the
point where the kernel assumes that there are no devices writing to memory.
Sound good?

-- 
Alan Curry
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/