Re: [KVM timekeeping 10/35] Fix deep C-state TSC desynchronization

From: Jan Kiszka
Date: Tue Sep 14 2010 - 18:27:17 EST


Am 14.09.2010 21:32, Zachary Amsden wrote:
> On 09/14/2010 12:40 AM, Jan Kiszka wrote:
>> Am 14.09.2010 11:27, Avi Kivity wrote:
>>
>>> On 09/14/2010 11:10 AM, Jan Kiszka wrote:
>>>
>>>> Am 20.08.2010 10:07, Zachary Amsden wrote:
>>>>
>>>>> When CPUs with unstable TSCs enter deep C-state, TSC may stop
>>>>> running. This causes us to require resynchronization. Since
>>>>> we can't tell when this may potentially happen, we assume the
>>>>> worst by forcing re-compensation for it at every point the VCPU
>>>>> task is descheduled.
>>>>>
>>>>> Signed-off-by: Zachary Amsden<zamsden@xxxxxxxxxx>
>>>>> ---
>>>>> arch/x86/kvm/x86.c | 2 +-
>>>>> 1 files changed, 1 insertions(+), 1 deletions(-)
>>>>>
>>>>> diff --git a/arch/x86/kvm/x86.c b/arch/x86/kvm/x86.c
>>>>> index 7fc4a55..52b6c21 100644
>>>>> --- a/arch/x86/kvm/x86.c
>>>>> +++ b/arch/x86/kvm/x86.c
>>>>> @@ -1866,7 +1866,7 @@ void kvm_arch_vcpu_load(struct kvm_vcpu
>>>>> *vcpu, int cpu)
>>>>> }
>>>>>
>>>>> kvm_x86_ops->vcpu_load(vcpu, cpu);
>>>>> - if (unlikely(vcpu->cpu != cpu)) {
>>>>> + if (unlikely(vcpu->cpu != cpu) || check_tsc_unstable()) {
>>>>> /* Make sure TSC doesn't go backwards */
>>>>> s64 tsc_delta = !vcpu->arch.last_host_tsc ? 0 :
>>>>> native_read_tsc() - vcpu->arch.last_host_tsc;
>>>>>
>>>> For yet unknown reason, this commit breaks Linux guests here if they
>>>> are
>>>> started with only a single VCPU. They hang during boot, obviously no
>>>> longer receiving interrupts.
>>>>
>>>> I'm using kvm-kmod against a 2.6.34 host kernel, so this may be a side
>>>> effect of the wrapping, though I cannot imagine how.
>>>>
>>>> Anyone any ideas?
>>>>
>>>>
>>>>
>>> Most likely, time went backwards, and some 'future - past' calculation
>>> resulted in a negative sleep value which was then interpreted as
>>> unsigned and resulted in a 2342525634 year sleep.
>>>
>> Looks like that's the case on first glance at the apic state.
>>
>
> This compensation effectively nulls the delta between current and last TSC:
>
> if (unlikely(vcpu->cpu != cpu) || check_tsc_unstable()) {
> /* Make sure TSC doesn't go backwards */
> s64 tsc_delta = !vcpu->arch.last_host_tsc ? 0 :
> native_read_tsc() -
> vcpu->arch.last_host_tsc;
> if (tsc_delta < 0)
> mark_tsc_unstable("KVM discovered backwards TSC");
> if (check_tsc_unstable())
> kvm_x86_ops->adjust_tsc_offset(vcpu, -tsc_delta);
> kvm_migrate_timers(vcpu);
> vcpu->cpu = cpu;
>
> If TSC has advanced quite a bit due to a TSC jump during sleep(*), it
> will adjust the offset backwards to compensate; similarly, if it has
> gone backwards, it will advance the offset.
>
> In neither case should the visible TSC go backwards, assuming
> last_host_tsc is recorded properly, and so kvmclock should be similarly
> unaffected.
>
> Perhaps the guest is more intelligent than we hope, and is comparing two
> different clocks: kvmclock or TSC with the rate of PIT interrupts. This
> could result in negative arithmetic begin interpreted as unsigned. Are
> you using PIT interrupt reinjection on this guest or passing
> -no-kvm-pit-reinjection?
>
>>
>>> Does your guest use kvmclock, tsc, or some other time source?
>>>
>> A kernel that has kvmclock support even hangs in SMP mode. The others
>> pick hpet or acpi_pm. TSC is considered unstable.
>>
>
> SMP mode here has always and will always be unreliable. Are you running
> on an Intel or AMD CPU? The origin of this code comes from a workaround
> for (*) in vendor-specific code, and perhaps it is inappropriate for both.

I'm on a fairly new Intel i7 (M 620). And I accidentally rebooted my box
a few hours ago. Well, the issue is gone now...

So I looked into the system logs and found this:

[18446744053.434939] PM: resume of devices complete after 4379.595 msecs
[18446744053.457133] PM: Finishing wakeup.
[18446744053.457135] Restarting tasks ...
[ 0.000999] Marking TSC unstable due to KVM discovered backwards TSC
[270103.974668] done.

From that point on the box was on hpet, including the time I did the
failing tests this morning. The kvm-kmod version loaded at this point
was based on kvm.git df549cfc.

But my /proc/cpuinfo claims "constant_tsc", and Linux is generally happy
with using it as clock source. Does this tell you anything?

Jan

Attachment: signature.asc
Description: OpenPGP digital signature