Re: [RFC][PATCH 21/26] alsa: ASoC: Add JZ4740 ASoC support

[Mark Brown]

On Wed, Jun 02, 2010 at 09:12:27PM +0200, Lars-Peter Clausen wrote:

Again, overall very good.

> +static int jz4740_i2s_set_clkdiv(struct snd_soc_dai *dai, int div_id, int div)
> +{
> +	struct jz4740_i2s *i2s = jz4740_dai_to_i2s(dai);
> +
> +	switch (div_id) {
> +	case JZ4740_I2S_BIT_CLK:
> +		if (div & 1 || div > 16)
> +			return -EINVAL;
> +		jz4740_i2s_write(i2s, JZ_REG_AIC_CLK_DIV, div - 1);
> +		break;
> +	default:
> +		return -EINVAL;
> +	}
> +
> +	return 0;
> +}

You can probably figure out the bit clock automatically by default...

> +	if (dai->active) {
> +		conf = jz4740_i2s_read(i2s, JZ_REG_AIC_CONF);
> +		conf &= ~JZ_AIC_CONF_ENABLE;
> +		jz4740_i2s_write(i2s, JZ_REG_AIC_CONF, conf);
> +
> +		clk_disable(i2s->clk_i2s);
> +	}
> +
> +	clk_disable(i2s->clk_aic);

Might make sense to manage this clock dynamically at runtime too for a
little extra power saving?

> +	i2s->clk_aic = clk_get(&pdev->dev, "aic");
> +	if (IS_ERR(i2s->clk_aic)) {
> +		ret = PTR_ERR(i2s->clk_aic);
> +		goto err_iounmap;
> +	}
> +
> +	i2s->clk_i2s = clk_get(&pdev->dev, "i2s");
> +	if (IS_ERR(i2s->clk_i2s)) {
> +		ret = PTR_ERR(i2s->clk_i2s);
> +		goto err_iounmap;
> +	}

Ideally you'd free the AIC clock when unwinding (and later stop it after
it was enabled).  Though since you don't do any error checking after
this point it's kind of academic :)
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/