Re: [v2 Patch 3/3] bonding: make bonding support netpoll

[Andy Gospodarek]

On Apr 6, 2010, at 10:32 PM, Cong Wang <amwang@xxxxxxxxxx> wrote:

> Andy Gospodarek wrote:
>> On Tue, Apr 06, 2010 at 12:38:16PM +0800, Cong Wang wrote:
>>> Cong Wang wrote:
>>>> Before I try to reproduce it, could you please try to replace
>>>> the  'read_lock()'
>>>> in slaves_support_netpoll() with 'read_lock_bh()'? (read_unlock()
>>>> too)  Try if this helps.
>>>>
>>> Confirmed. Please use the attached patch instead, for your testing.
>>>
>>> Thanks!
>>>
>> Moving those locks to bh-locks will not resolve this.  I tried that
>> yesterday and tried your new patch today without success.  That
>> warning
>> is a WARN_ON_ONCE so you need to reboot to see that it is still a
>> problem.  Simply unloading and loading the new module is not an
>> accurate
>> test.
>> Also, my system still hangs when removing the bonding module.  I do
>> not
>> think you intended to fix this with the patch, but wanted it to be
>> clear
>> to everyone on the list.
>
>
> Actually I did reboot and then tested the module. I didn't get any
> warning.
> I just tried again today, and no warnings at all.
>
> For removing bonding module, you may need another fix of mine,
> which is to fix a potential deadlock of workqueue. Try:
>
> http://lkml.org/lkml/2010/4/1/58
>
>> You should also configure your kernel with a some of the lock
>> debugging
>> enabled.  I've been using the following:
>> CONFIG_DETECT_HUNG_TASK=y
>> CONFIG_DEBUG_SPINLOCK=y
>> CONFIG_DEBUG_MUTEXES=y
>> CONFIG_DEBUG_LOCK_ALLOC=y
>> CONFIG_PROVE_LOCKING=y
>> CONFIG_LOCKDEP=y
>> CONFIG_LOCK_STAT=y
>> CONFIG_DEBUG_LOCKDEP=y
>
>
> Sure, I always keep these.
>
>> Here is the output when I remove a slave from the bond.  My
>> xmit_roundrobin patch from earlier (replacing read_lock with
>> read_trylock) was applied.  It might be helpful for you when
>> debugging
>> these issues.
>
>
> I don't apply your patch, just tested my patch.
>
>> Dead loop on virtual device bond0, fix it urgently!
>
> Please provide your bonding configuration and steps to reproduce it.
>

My first response in this thread provides the commands and
configuration needed to reproduce this.

> What I did is:
>
> 1. Load bonding module with "mode=0 miimon=100"
> 2. Enslave eth0 and active bond0
> 3. Load netconsole and send messages via bond0
> 4. Remove eth0 from bond0
> 5. Remove bonding module
> 6. Remove netconsole module

Thanks for sending your configuration.

What values are in /proc/sys/kernel/printk?

> And no deadlocks, no warnings.
>
> Thanks.
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/