Re: ext4_fiemap gives 0 extents for files smaller than a block(patch included)

[Leonard Michlmayr]

Thank you for your reply.

> >
> > @@ -3700,7 +3701,8 @@
> >  		start_blk = start >> inode->i_sb->s_blocksize_bits;
> > -		len_blks = len >> inode->i_sb->s_blocksize_bits;
> > +		end_blk = (start + len - 1) >> inode->i_sb->s_blocksize_bits;
> > +		len_blks = end_blk - start_blk + 1;
> 
> I don't think this is quite correct either.  For example, if blocksize  
> is 1024
> and start is 1023 (start_blk = 0) and len is 2 (end = 1024, end_blk =  
> 1) then
> len_blks = 2 which is too much.

I think that len_blks = 2 is the correct value, because the requested
region extends into 2 blocks (namely 0 and 1). If both blocks are in two
separate extents, then ext4_ext_walk_space should report 2 extents. (If
it's the same extent, only 1 will be reported anyways)

> I think the right calculation here is:
> 
>                    end_blk = (start + len + inode->i_sb->s_blocksize - 1) >>
>                              inode->i_sb->s_blocksize_bits;
>                    len_blks = end_blk - start_blk;
> 

This is exactly the same (provided that len > 0). You can convince
yourself easily that ((blocksize + x) >> blocksize_bits == x >>
blocksize_bits + 1) for any positive x, because the lower bits of
blocksize are all 0. (Your calculation would handle the case len == 0
right, if that was allowed.)

Regards
Leonard


--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/