[PATCH 15/20] cciss: Don't check h->busy_initializing in cciss_open().

[Stephen M. Cameron]

Don't check h->busy_initializing in cciss_open().  Open won't be
called before things are ready, but h->busy_initializing won't be
unset until after the initial rebuild_lun_table is finished.  But,
to read the partitions, cciss_open will be called for each logical
drive during rebuild_lun_table.  If cciss_open checks h->busy_initializing,
then the reading of the partition information during the initial
rebuild_lun_table will fail, which is especially bad news if it
happens to be your boot device.

Signed-off-by: Stephen M. Cameron <scameron@xxxxxxxxxxxxxxxxxx>
---

 drivers/block/cciss.c |    2 +-
 1 files changed, 1 insertions(+), 1 deletions(-)

diff --git a/drivers/block/cciss.c b/drivers/block/cciss.c
index 56eeb68..0ff665e 100644
--- a/drivers/block/cciss.c
+++ b/drivers/block/cciss.c
@@ -829,7 +829,7 @@ static int cciss_open(struct block_device *bdev, fmode_t mode)
 	printk(KERN_DEBUG "cciss_open %s\n", bdev->bd_disk->disk_name);
 #endif				/* CCISS_DEBUG */
 
-	if (host->busy_initializing || drv->busy_configuring)
+	if (drv->busy_configuring)
 		return -EBUSY;
 	/*
 	 * Root is allowed to open raw volume zero even if it's not configured

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/