[PATCH v4] Resurrect IT8172 IDE controller driver

From: Shane McDonald
Date: Tue Dec 30 2008 - 22:23:20 EST

Support for the IT8172 IDE controller was removed from the kernel
sometime after 2.6.18. Support for the only boards that used the IT8172
was removed from the kernel after 2.6.18, as they had never compiled
since 2.6.0. However, there are a couple of platforms that use this
chip: the PMC-Sierra Xiao Hu thin-client computer, which is no longer
in production, and the Linksys NSS4000 Network Attached Storage box,
which is based on the Xiao Hu board. I am attempting to add support
for the Xiao Hu to the kernel, and this IT8172 IDE controller is the
first bit of code in this effort.

This patch resurrects the IT8172 IDE controller code. I began with
the 2.6.18 version of the it8172.c file, and have moved it forward so
that it works with the latest version of the kernel. I have run this
driver on a PMC-Sierra Xiao Hu board with the 2.6.28 kernel, and
I have had no problems with it in my configuration. The attached patch
applies cleanly against 2.6.28.

Signed-off-by: Shane McDonald <mcdonald.shane@xxxxxxxxx>
---
drivers/ide/Kconfig | 7 +
drivers/ide/Makefile | 1
drivers/ide/it8172.c | 173 ++++++++++++++++++++++++++++++++++++++
include/linux/pci_ids.h | 1
4 files changed, 182 insertions(+)

Changes since version 3 of the patch:
- corrected settings of RTx and PWx for PIO mode 1
- removed code duplication for different drives when setting PIO modes
- simplified test for IORDY support
- simplified calculation of bit settings for UDMA modes
- removed remnants of support for SWDMA
- corrected a coding style issue

diff -uprN a/drivers/ide/Kconfig b/drivers/ide/Kconfig
--- a/drivers/ide/Kconfig 2008-12-30 20:53:32.000000000 -0600
+++ b/drivers/ide/Kconfig 2008-12-30 20:55:04.000000000 -0600
@@ -524,6 +524,13 @@ config BLK_DEV_PIIX
This allows the kernel to change PIO, DMA and UDMA speeds and to
configure the chip to optimum performance.

+config BLK_DEV_IT8172
+ tristate "IT8172 IDE support"
+ select BLK_DEV_IDEDMA_PCI
+ help
+ This driver adds support for the IDE controller on the
+ IT8172 System Controller.
+
config BLK_DEV_IT8213
tristate "IT8213 IDE support"
select BLK_DEV_IDEDMA_PCI
diff -uprN a/drivers/ide/Makefile b/drivers/ide/Makefile
--- a/drivers/ide/Makefile 2008-12-30 20:53:42.000000000 -0600
+++ b/drivers/ide/Makefile 2008-12-30 20:55:14.000000000 -0600
@@ -46,6 +46,7 @@ obj-$(CONFIG_BLK_DEV_SC1200) += sc1200.
obj-$(CONFIG_BLK_DEV_CY82C693) += cy82c693.o
obj-$(CONFIG_BLK_DEV_DELKIN) += delkin_cb.o
obj-$(CONFIG_BLK_DEV_HPT366) += hpt366.o
+obj-$(CONFIG_BLK_DEV_IT8172) += it8172.o
obj-$(CONFIG_BLK_DEV_IT8213) += it8213.o
obj-$(CONFIG_BLK_DEV_IT821X) += it821x.o
obj-$(CONFIG_BLK_DEV_JMICRON) += jmicron.o
diff -uprN a/drivers/ide/it8172.c b/drivers/ide/it8172.c
--- a/drivers/ide/it8172.c 1969-12-31 18:00:00.000000000 -0600
+++ b/drivers/ide/it8172.c 2008-12-30 20:55:29.000000000 -0600
@@ -0,0 +1,173 @@
+/*
+ *
+ * BRIEF MODULE DESCRIPTION
+ * IT8172 IDE controller support
+ *
+ * Copyright (C) 2000 MontaVista Software Inc.
+ * Copyright (C) 2008 Shane McDonald
+ *
+ * This program is free software; you can redistribute it and/or modify it
+ * under the terms of the GNU General Public License as published by the
+ * Free Software Foundation; either version 2 of the License, or (at your
+ * option) any later version.
+ *
+ * THIS SOFTWARE IS PROVIDED ``AS IS'' AND ANY EXPRESS OR IMPLIED
+ * WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF
+ * MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN
+ * NO EVENT SHALL THE AUTHOR BE LIABLE FOR ANY DIRECT, INDIRECT,
+ * INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT
+ * NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF
+ * USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON
+ * ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT
+ * (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF
+ * THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
+ *
+ * You should have received a copy of the GNU General Public License along
+ * with this program; if not, write to the Free Software Foundation, Inc.,
+ * 675 Mass Ave, Cambridge, MA 02139, USA.
+ */
+
+#include <linux/module.h>
+#include <linux/types.h>
+#include <linux/kernel.h>
+#include <linux/ioport.h>
+#include <linux/pci.h>
+#include <linux/ide.h>
+#include <linux/init.h>
+
+#define DRV_NAME "IT8172"
+
+static void it8172_set_pio_mode(ide_drive_t *drive, const u8 pio)
+{
+ ide_hwif_t *hwif = HWIF(drive);
+ struct pci_dev *dev = to_pci_dev(hwif->dev);
+ u16 drive_enables;
+ u32 drive_timing;
+
+ /* RTx PWx */
+ static const u8 timings[][2] = {
+ { 7, 7 },
+ { 7, 4 },
+ { 3, 3 },
+ { 2, 2 },
+ { 1, 2 }, };
+ /*
+ * The highest value of DIOR/DIOW pulse width and recovery time
+ * that can be set in the IT8172 is 8 PCI clock cycles. As a result,
+ * it cannot be configured for PIO mode 0. This table sets these
+ * parameters to the maximum supported by the IT8172.
+ */
+
+ pci_read_config_word(dev, 0x40, &drive_enables);
+ pci_read_config_dword(dev, 0x44, &drive_timing);
+
+ /*
+ * Enable port 0x44. The IT8172 spec is confused; it calls
+ * this register the "Slave IDE Timing Register", but in fact,
+ * it controls timing for both master and slave drives.
+ */
+ drive_enables |= 0x4000;
+
+ drive_enables &= drive->dn ? 0xc006 : 0xc060;
+ if (drive->media == ide_disk)
+ /* enable prefetch */
+ drive_enables |= 0x0004 << (drive->dn * 4);
+ if (ata_id_has_iordy(drive->id))
+ /* enable IORDY sample-point */
+ drive_enables |= 0x0002 << (drive->dn * 4);
+
+ drive_timing &= drive->dn ? 0x00003f00 : 0x000fc000;
+ drive_timing |= ((timings[pio][0] << 11) | (timings[pio][1] << 8))
+ << (drive->dn * 6);
+
+ pci_write_config_word(dev, 0x40, drive_enables);
+ pci_write_config_dword(dev, 0x44, drive_timing);
+}
+
+static void it8172_set_dma_mode(ide_drive_t *drive, const u8 speed)
+{
+ ide_hwif_t *hwif = HWIF(drive);
+ struct pci_dev *dev = to_pci_dev(hwif->dev);
+ int a_speed = 3 << (drive->dn * 4);
+ int u_flag = 1 << drive->dn;
+ int u_speed = 0;
+ u8 reg48, reg4a;
+
+ pci_read_config_byte(dev, 0x48, &reg48);
+ pci_read_config_byte(dev, 0x4a, &reg4a);
+
+ if (speed >= XFER_UDMA_0) {
+ u8 udma = speed - XFER_UDMA_0;
+ u_speed = udma << (drive->dn * 4);
+
+ pci_write_config_byte(dev, 0x48, reg48 | u_flag);
+ reg4a &= ~a_speed;
+ pci_write_config_byte(dev, 0x4a, reg4a | u_speed);
+ } else {
+ const u8 mwdma_to_pio[] = { 0, 3, 4 };
+ u8 pio;
+
+ pci_write_config_byte(dev, 0x48, reg48 & ~u_flag);
+ pci_write_config_byte(dev, 0x4a, reg4a & ~a_speed);
+
+ pio = mwdma_to_pio[speed - XFER_MW_DMA_0];
+
+ it8172_set_pio_mode(drive, pio);
+ }
+}
+
+
+static const struct ide_port_ops it8172_port_ops = {
+ .set_pio_mode = it8172_set_pio_mode,
+ .set_dma_mode = it8172_set_dma_mode,
+};
+
+static const struct ide_port_info it8172_port_info __devinitdata = {
+ .name = DRV_NAME,
+ .port_ops = &it8172_port_ops,
+ .enablebits = { {0x41, 0x80, 0x80}, {0x00, 0x00, 0x00} },
+ .host_flags = IDE_HFLAG_SINGLE,
+ .pio_mask = ATA_PIO4 & ~ATA_PIO0,
+ .mwdma_mask = ATA_MWDMA2,
+ .udma_mask = ATA_UDMA2,
+};
+
+static int __devinit it8172_init_one(struct pci_dev *dev,
+ const struct pci_device_id *id)
+{
+ if ((dev->class >> 8) != PCI_CLASS_STORAGE_IDE)
+ return -ENODEV; /* IT8172 is more than an IDE controller */
+ return ide_pci_init_one(dev, &it8172_port_info, NULL);
+}
+
+static struct pci_device_id it8172_pci_tbl[] = {
+ { PCI_VDEVICE(ITE, PCI_DEVICE_ID_ITE_8172), 0 },
+ { 0, },
+};
+MODULE_DEVICE_TABLE(pci, it8172_pci_tbl);
+
+static struct pci_driver it8172_pci_driver = {
+ .name = "IT8172_IDE",
+ .id_table = it8172_pci_tbl,
+ .probe = it8172_init_one,
+ .remove = ide_pci_remove,
+ .suspend = ide_pci_suspend,
+ .resume = ide_pci_resume,
+};
+
+static int __init it8172_ide_init(void)
+{
+ return ide_pci_register_driver(&it8172_pci_driver);
+}
+
+static void __exit it8172_ide_exit(void)
+{
+ pci_unregister_driver(&it8172_pci_driver);
+}
+
+module_init(it8172_ide_init);
+module_exit(it8172_ide_exit);
+
+MODULE_AUTHOR("Steve Longerbeam");
+MODULE_DESCRIPTION("PCI driver module for ITE 8172 IDE");
+MODULE_LICENSE("GPL");
diff -uprN a/include/linux/pci_ids.h b/include/linux/pci_ids.h
--- a/include/linux/pci_ids.h 2008-12-30 20:54:49.000000000 -0600
+++ b/include/linux/pci_ids.h 2008-12-30 20:55:44.000000000 -0600
@@ -1658,6 +1658,7 @@
#define PCI_VENDOR_ID_ROCKWELL 0x127A

#define PCI_VENDOR_ID_ITE 0x1283
+#define PCI_DEVICE_ID_ITE_8172 0x8172
#define PCI_DEVICE_ID_ITE_8211 0x8211
#define PCI_DEVICE_ID_ITE_8212 0x8212
#define PCI_DEVICE_ID_ITE_8213 0x8213
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/