2.6.28: md0: unknown partition table

From: Justin Piszcz
Date: Tue Dec 30 2008 - 07:25:31 EST


Had a question about the new option in 2.6.28:

[ 7.655297] usb 6-2: configuration #1 chosen from 1 choice
[ 7.663280] hub 6-2:1.0: USB hub found
[ 7.666533] hub 6-2:1.0: 3 ports detected
[ 7.698008] udev: renamed network interface eth0_rename to eth1
[ 7.824538] md1:<6> md0: unknown partition table
[ 7.835978] [ 7.950237] usb 6-2.1: new full speed USB device using uhci_hcd and address 3
[ 8.081335] usb 6-2.1: configuration #1 chosen from 1 choice

See line:
[ 7.824538] md1:<6> md0: unknown partition table

This is swap, I do not recall seeing this error in kernels < 2.6.28, should
the kernel not scan for partitions on a swap-based parititon? [1]

[2] partitions for mdadm/raid are usually md0_p1 md1_p2 why would it scan for
partitions on /dev/md0, /dev/md1, /dev/md2 as they are 'block devices' e.g.,
similar to /dev/sda, /dev/sdb, /dev/sdc

I do have the option checked off:
[*] Autodetect RAID arrays during kernel boot

As I compile everything in statically, no modules are used.

If I disable that option, would my system still boot/that would get rid of the error/so it does not try to scan for partitions on swap?

Justin.

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/