[PATCH 04/16] Blackfin SPI Driver: use len_in_bytes when we care about the number of bytes transferred

[Bryan Wu]

From: Mike Frysinger <vapier.adi@xxxxxxxxx>

Use len_in_bytes when we care about the number of bytes transferred
rather than the number of spi transactions. (this value will be the
same for 8bit transfers, but not any other sizes)

Signed-off-by: Mike Frysinger <vapier.adi@xxxxxxxxx>
Signed-off-by: Bryan Wu <cooloney@xxxxxxxxxx>
---
 drivers/spi/spi_bfin5xx.c |    6 +++---
 1 files changed, 3 insertions(+), 3 deletions(-)

diff --git a/drivers/spi/spi_bfin5xx.c b/drivers/spi/spi_bfin5xx.c
index 6c5671e..cc415e8 100644
--- a/drivers/spi/spi_bfin5xx.c
+++ b/drivers/spi/spi_bfin5xx.c
@@ -803,7 +803,7 @@ static void pump_transfers(unsigned long data)
 			if (bfin_addr_dcachable((unsigned long) drv_data->rx))
 				invalidate_dcache_range((unsigned long) drv_data->rx,
 							(unsigned long) (drv_data->rx +
-							drv_data->len));
+							drv_data->len_in_bytes));
 
 			/* clear tx reg soformer data is not shifted out */
 			write_TDBR(drv_data, 0xFFFF);
@@ -829,7 +829,7 @@ static void pump_transfers(unsigned long data)
 			if (bfin_addr_dcachable((unsigned long) drv_data->tx))
 				flush_dcache_range((unsigned long) drv_data->tx,
 						(unsigned long) (drv_data->tx +
-						drv_data->len));
+						drv_data->len_in_bytes));
 
 			/* start dma */
 			dma_enable_irq(drv_data->dma_channel);
@@ -892,7 +892,7 @@ static void pump_transfers(unsigned long data)
 			message->state = ERROR_STATE;
 		} else {
 			/* Update total byte transfered */
-			message->actual_length += drv_data->len;
+			message->actual_length += drv_data->len_in_bytes;
 
 			/* Move to next transfer of this msg */
 			message->state = next_transfer(drv_data);
-- 
1.5.6.3
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/