Re: [ibm-acpi-devel] Fan level 7 after resume wit 2.6.28-rc3

[Henrique de Moraes Holschuh]

On Thu, 06 Nov 2008, Tino Keitel wrote:
> The whole fan level stuff looks a bit complicated to me. Especially the

It is.  The sysfs hwmon interface does not map 1:1 with the three possible
thinkpad fan control interfaces.  fan_control_desired_level is used for that
interface mainly, since I have to remember the last state used that was in
the set of 0-7, ignoring AUTO (which is a separate pwm control mode for
hwmon) and full-speed (which is a separate pwm control mode for hwmon).

It is hijacked by fan_suspend/fan_resume to store state between
sleep/resume, because that was convenient.  Too bad I failed to notice it
would not work properly for that.

> The attached patch tries to simplify this a bit. It sets

NAK, it would break a lot of stuff.   See my previous reply on this thread
for *some* of the stuff it would break.

I will have a proper patch out probably within 24h but most certainly before
next Monday.

Meanwhile, I suggest you just remove the calls to fan_suspend and fan_resume
as a workaround.

-- 
  "One disk to rule them all, One disk to find them. One disk to bring
  them all and in the darkness grind them. In the Land of Redmond
  where the shadows lie." -- The Silicon Valley Tarot
  Henrique Holschuh
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/