Re: [PATCH 1/1] cciss: read config to obtain max outstandingcommands per controller

[Andrew Morton]

On Tue, 1 Jul 2008 16:02:47 -0500
Mike Miller <mike.miller@xxxxxx> wrote:

> This patch changes the way we determine the maximum number of outstanding
> commands for each controller. Most Smart Array controllers can support up
> to 1024 commands, the notable exceptions are the E200 and E200i.
> The next generation of controllers which were just added support a mode of
> operation called Zero Memory Raid (ZMR).  In this mode they only support 64 
> outstanding commands. In Full Function Raid (FFR) mode they support 1024. 
> We have been setting the queue depth by arbitrarily assigning some value for
> each controller. We needed a better way to set the queue depth to avoid lots 
> of annoying "fifo full" messages. So we made the driver a little smarter. We 
> now read the config table and subtract 4 from the returned value. The -4 is 
> to allow some room for ioctl calls which are not tracked the same way as io 
> commands are tracked.

What would be the effect of _not_ having this patch upon users of the
new hardware?

If the answer is "bad" then we should get this change into 2.6.26 and
2.6.25.x, because people will surely be running those kernels on the
new hardware.
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/