[PATCH] [RFC v3] OF: OpenFirmware bindings for the mmc_spi driver

[Anton Vorontsov]

Here is v3. I'm out of ideas if you won't like it. :-)

v3:
- Now these bindings are using bus notifiers chain, thus we adhere to the
  spi bus.

  By the way, this scheme (IMO) looks good for I2C devices which needs
  platform_data extracted from the device tree too (Cc'ing Jochen).

- Plus changed the OF bindings themselves, implemented voltage-range
  property. (Pierre, please take a look at vddrange_to_ocrmask(). I
  wonder if you would like this in the MMC core instead, with a kernel
  doc, of course.)

v2:
- Bindings were adhered to the MMC_SPI driver. Withdrawn by Pierre Ossman.

v1:
- Bindings were adhered to the OF SPI core. Withdrawn by OF people.

Signed-off-by: Anton Vorontsov <avorontsov@xxxxxxxxxxxxx>
---
 Documentation/powerpc/booting-without-of.txt |   21 +++
 drivers/of/Kconfig                           |    8 +
 drivers/of/Makefile                          |    1 +
 drivers/of/of_mmc_spi.c                      |  210 ++++++++++++++++++++++++++
 4 files changed, 240 insertions(+), 0 deletions(-)
 create mode 100644 drivers/of/of_mmc_spi.c

diff --git a/Documentation/powerpc/booting-without-of.txt b/Documentation/powerpc/booting-without-of.txt
index 6e1711c..6c55f3f 100644
--- a/Documentation/powerpc/booting-without-of.txt
+++ b/Documentation/powerpc/booting-without-of.txt
@@ -3143,7 +3143,28 @@ platforms are moved over to use the flattened-device-tree model.
 			};
 		};
 
+    ...) MMC-over-SPI
 
+      Required properties:
+      - compatible : should be "mmc-spi".
+      - reg : should specify SPI address (chip-select number).
+      - max-speed : (optional) maximum frequency for this device (Hz).
+      - voltage-range : two cells are required, first cell specifies minimum
+        slot voltage (mV), second cell specifies maximum slot voltage (mV).
+      - gpios : (optional) may specify GPIOs in this order: Write-Protect GPIO,
+        Card-Detect GPIO.
+
+      Example:
+
+	mmc-slot@0 {
+		compatible = "mmc-spi";
+		reg = <0>;
+		max-speed = <50000000>;
+		/* Unregulated slot. */
+		voltage-range = <3300 3300>;
+		gpios = <&sdcsr_pio 1 0   /*  WP */
+			 &sdcsr_pio 0 1>; /* nCD */
+	};
 
 VII - Marvell Discovery mv64[345]6x System Controller chips
 ===========================================================
diff --git a/drivers/of/Kconfig b/drivers/of/Kconfig
index 3a7a11a..aadbfb3 100644
--- a/drivers/of/Kconfig
+++ b/drivers/of/Kconfig
@@ -13,3 +13,11 @@ config OF_I2C
 	depends on PPC_OF && I2C
 	help
 	  OpenFirmware I2C accessors
+
+config OF_MMC_SPI
+	bool "OpenFirmware bindings for MMC/SD over SPI"
+	depends on PPC_OF && SPI
+	default y if MMC_SPI
+	help
+	  Say Y here to enable OpenFirmware bindings for the MMC/SD over SPI
+	  driver.
diff --git a/drivers/of/Makefile b/drivers/of/Makefile
index 548772e..a7c44fc 100644
--- a/drivers/of/Makefile
+++ b/drivers/of/Makefile
@@ -2,3 +2,4 @@ obj-y = base.o
 obj-$(CONFIG_OF_DEVICE) += device.o platform.o
 obj-$(CONFIG_OF_GPIO)   += gpio.o
 obj-$(CONFIG_OF_I2C)	+= of_i2c.o
+obj-$(CONFIG_OF_MMC_SPI)	+= of_mmc_spi.o
diff --git a/drivers/of/of_mmc_spi.c b/drivers/of/of_mmc_spi.c
new file mode 100644
index 0000000..aa4e017
--- /dev/null
+++ b/drivers/of/of_mmc_spi.c
@@ -0,0 +1,210 @@
+/*
+ * OpenFirmware bindings for the MMC-over-SPI driver
+ *
+ * Copyright (c) MontaVista Software, Inc. 2008.
+ *
+ * Author: Anton Vorontsov <avorontsov@xxxxxxxxxxxxx>
+ *
+ * This program is free software; you can redistribute  it and/or modify it
+ * under  the terms of  the GNU General  Public License as published by the
+ * Free Software Foundation;  either version 2 of the  License, or (at your
+ * option) any later version.
+ */
+
+#include <linux/init.h>
+#include <linux/device.h>
+#include <linux/notifier.h>
+#include <linux/gpio.h>
+#include <linux/of.h>
+#include <linux/of_gpio.h>
+#include <linux/of_platform.h>
+#include <linux/spi/spi.h>
+#include <linux/spi/mmc_spi.h>
+#include <linux/mmc/host.h>
+
+/*
+ * XXX: Place it somewhere in the generic MMC code?
+ */
+static int vdd_to_bitnum(int vdd)
+{
+	int bit;
+	const int max_bit = ilog2(MMC_VDD_35_36);
+
+	if (vdd < 1650 || vdd > 3600)
+		return -EINVAL;
+
+	if (vdd >= 1650 && vdd <= 1950)
+		return ilog2(MMC_VDD_165_195);
+
+	/* base 2000 mV, step 100 mV, bit's base 8 */
+	bit = (vdd - 2000) / 100 + 8;
+	if (bit > max_bit)
+		return max_bit;
+	return bit;
+}
+
+static int vddrange_to_ocrmask(int vdd_min, int vdd_max, unsigned int *mask)
+{
+	if (vdd_max < vdd_min)
+		return -EINVAL;
+
+	vdd_max = vdd_to_bitnum(vdd_max);
+	if (vdd_max < 0)
+		return -EINVAL;
+
+	vdd_min = vdd_to_bitnum(vdd_min);
+	if (vdd_min < 0)
+		return -EINVAL;
+
+	/* fill the mask, from max bit to min bit */
+	while (vdd_max >= vdd_min)
+		*mask |= 1 << vdd_max--;
+	return 0;
+}
+
+struct of_mmc_spi {
+	int wp_gpio;
+	int cd_gpio;
+	struct mmc_spi_platform_data mmc_pdata;
+};
+
+static struct of_mmc_spi *to_of_mmc_spi(struct device *dev)
+{
+	return container_of(dev->platform_data, struct of_mmc_spi, mmc_pdata);
+}
+
+static int mmc_get_ro(struct device *dev)
+{
+	struct of_mmc_spi *oms = to_of_mmc_spi(dev);
+
+	return gpio_get_value(oms->wp_gpio);
+}
+
+static int mmc_get_cd(struct device *dev)
+{
+	struct of_mmc_spi *oms = to_of_mmc_spi(dev);
+
+	return gpio_get_value(oms->cd_gpio);
+}
+
+static int of_mmc_spi_add(struct device *dev)
+{
+	int ret = -EINVAL;
+	struct device_node *np = dev->archdata.of_node;
+	struct of_mmc_spi *oms;
+	const u32 *voltage_range;
+	int size;
+
+	if (!np || !of_device_is_compatible(np, "mmc-spi"))
+		return NOTIFY_DONE;
+
+	oms = kzalloc(sizeof(*oms), GFP_KERNEL);
+	if (!oms)
+		return notifier_to_errno(-ENOMEM);
+
+	/* We don't support interrupts yet, let's poll. */
+	oms->mmc_pdata.caps |= MMC_CAP_NEEDS_POLL;
+
+	voltage_range = of_get_property(np, "voltage-range", &size);
+	if (!voltage_range || size < sizeof(*voltage_range) * 2) {
+		dev_err(dev, "OF: voltage-range unspecified\n");
+		goto err_ocr;
+	}
+
+	ret = vddrange_to_ocrmask(voltage_range[0], voltage_range[1],
+				  &oms->mmc_pdata.ocr_mask);
+	if (ret) {
+		dev_err(dev, "OF: specified voltage-range is invalid\n");
+		goto err_ocr;
+	}
+
+	oms->wp_gpio = of_get_gpio(np, 0);
+	if (gpio_is_valid(oms->wp_gpio)) {
+		ret = gpio_request(oms->wp_gpio, dev->bus_id);
+		if (ret < 0)
+			goto err_wp_gpio;
+		oms->mmc_pdata.get_ro = &mmc_get_ro;
+	}
+
+	oms->cd_gpio = of_get_gpio(np, 1);
+	if (gpio_is_valid(oms->cd_gpio)) {
+		ret = gpio_request(oms->cd_gpio, dev->bus_id);
+		if (ret < 0)
+			goto err_cd_gpio;
+		oms->mmc_pdata.get_cd = &mmc_get_cd;
+	}
+
+	dev->platform_data = &oms->mmc_pdata;
+
+	return NOTIFY_STOP;
+
+err_cd_gpio:
+	if (gpio_is_valid(oms->wp_gpio))
+		gpio_free(oms->wp_gpio);
+err_wp_gpio:
+err_ocr:
+	kfree(oms);
+	return notifier_to_errno(ret);
+}
+
+static int of_mmc_spi_del(struct device *dev)
+{
+	struct device_node *np = dev->archdata.of_node;
+	struct of_mmc_spi *oms;
+
+	if (!np || !of_device_is_compatible(np, "mmc-spi") ||
+			!dev->platform_data)
+		return NOTIFY_DONE;
+
+	oms = to_of_mmc_spi(dev);
+
+	if (gpio_is_valid(oms->cd_gpio))
+		gpio_free(oms->cd_gpio);
+	if (gpio_is_valid(oms->wp_gpio))
+		gpio_free(oms->wp_gpio);
+
+	kfree(oms);
+	return NOTIFY_STOP;
+}
+
+static int of_mmc_spi_notify(struct notifier_block *nb, unsigned long action,
+			     void *_dev)
+{
+	struct device *dev = _dev;
+
+	switch (action) {
+	case BUS_NOTIFY_ADD_DEVICE:
+		return of_mmc_spi_add(dev);
+	case BUS_NOTIFY_DEL_DEVICE:
+		return of_mmc_spi_del(dev);
+	};
+	return NOTIFY_DONE;
+}
+
+static struct notifier_block of_mmc_spi_notifier = {
+	.notifier_call = of_mmc_spi_notify,
+};
+
+/*
+ * Should be called early enough, but after SPI core initializes. So, we
+ * use subsys_initcall (as in the SPI core), and link order guaranties
+ * that we'll be called at the right time.
+ */
+static int __init of_mmc_spi_init(void)
+{
+	int ret;
+
+	ret = bus_register_notifier(&spi_bus_type, &of_mmc_spi_notifier);
+	if (ret) {
+		pr_err("%s: unable to register notifier on the spi bus\n",
+			__func__);
+		return ret;
+	}
+
+	return 0;
+}
+subsys_initcall(of_mmc_spi_init);
+
+MODULE_DESCRIPTION("OpenFirmware bindings for the MMC-over-SPI driver");
+MODULE_AUTHOR("Anton Vorontsov <avorontsov@xxxxxxxxxxxxx>");
+MODULE_LICENSE("GPL");
-- 
1.5.5.1
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/