Re: 2.6.24-rc2-mm1 -- QLogics ISP1020 gone missing

[Andy Whitcroft]

All of our machines with QLogics ISP1020 cards seem to have lost them on
boot with 2.6.24-rc1-mm1+hotfixes.

# lspci
0000:00:0a.0 SCSI storage controller: QLogic Corp. ISP1020 Fast-wide
SCSI (rev 05)

# lspci -n
0000:00:0a.0 0100: 1077:1020 (rev 05)

# lspci -v -v
0000:00:0a.0 SCSI storage controller: QLogic Corp. ISP1020 Fast-wide SCSI (rev 05)
        Subsystem: QLogic Corp.: Unknown device 0000
        Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop- ParErr- Stepping- SERR+ FastB2B-
        Status: Cap- 66MHz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
        Latency: 248, Cache Line Size: 0x08 (32 bytes)
        Interrupt: pin A routed to IRQ 23
        Region 0: I/O ports at fc00 [size=256]
        Region 1: Memory at fa000000 (32-bit, non-prefetchable) [size=4K]

These devices are normally reported as below, which I note is not as a
1020?

qla1280: QLA1040 found on PCI bus 0, dev 10
scsi(0:0): Resetting SCSI BUS
scsi0 : QLogic QLA1040 PCI to SCSI Host Adapter
	Firmware version:  7.65.06, Driver version 3.26

There is nothing major around in the area so I am somewhat bemused.

-apw
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/