Re: [1/2] 2.6.23-rc3: known regressions with patches: 8250 claims nonexisting device blocking IO port

From: Bjorn Helgaas
Date: Wed Aug 29 2007 - 12:36:39 EST


On Wednesday 29 August 2007 09:28:01 am Michal Piotrowski wrote:
> Subject : 8250 claims non existing device blocking IO port
> References : http://lkml.org/lkml/2007/8/18/20
> Last known good : ?
> Submitter : Andrey Borzenkov <arvidjaar@xxxxxxx>
> Caused-By : ?
> Handled-By : Bjorn Helgaas <bjorn.helgaas@xxxxxx>
> Patch : http://lkml.org/lkml/2007/8/21/291
> Status : patch was suggested

The following patch fixes this regression (confirmed by Andrey).
Please queue it for 2.6.23. I'll come back later for another
try at sorting this all out.


PNP: remove SMCf010 quirk

If the quirk enables the SIR part of the SMCf010 device, the 8250 driver
may claim it as a legacy ttyS device, which makes the legacy probe in the
smsc-ircc2 driver fail.

Signed-off-by: Bjorn Helgaas <bjorn.helgaas@xxxxxx>

Index: w/drivers/pnp/quirks.c
===================================================================
--- w.orig/drivers/pnp/quirks.c 2007-08-29 10:23:52.000000000 -0600
+++ w/drivers/pnp/quirks.c 2007-08-29 10:24:01.000000000 -0600
@@ -107,108 +107,6 @@
"pnp: SB audio device quirk - increasing port range\n");
}

-static int quirk_smc_fir_enabled(struct pnp_dev *dev)
-{
- unsigned long firbase;
- u8 bank, high, low, chip;
-
- if (!pnp_port_valid(dev, 1))
- return 0;
-
- firbase = pnp_port_start(dev, 1);
-
- /* Select register bank 3 */
- bank = inb(firbase + 7);
- bank &= 0xf0;
- bank |= 3;
- outb(bank, firbase + 7);
-
- high = inb(firbase + 0);
- low = inb(firbase + 1);
- chip = inb(firbase + 2);
-
- /* This corresponds to the check in smsc_ircc_present() */
- if (high == 0x10 && low == 0xb8 && (chip == 0xf1 || chip == 0xf2))
- return 1;
-
- return 0;
-}
-
-static void quirk_smc_enable(struct pnp_dev *dev)
-{
- struct resource fir, sir, irq;
-
- pnp_activate_dev(dev);
- if (quirk_smc_fir_enabled(dev))
- return;
-
- /*
- * Sometimes the BIOS claims the device is enabled, but it reports
- * the wrong FIR resources or doesn't properly configure ISA or LPC
- * bridges on the way to the device.
- *
- * HP nc6000 and nc8000/nw8000 laptops have known problems like
- * this. Fortunately, they do fix things up if we auto-configure
- * the device using its _PRS and _SRS methods.
- */
- dev_err(&dev->dev, "%s not responding at SIR 0x%lx, FIR 0x%lx; "
- "auto-configuring\n", dev->id->id,
- (unsigned long)pnp_port_start(dev, 0),
- (unsigned long)pnp_port_start(dev, 1));
-
- pnp_disable_dev(dev);
- pnp_init_resource_table(&dev->res);
- pnp_auto_config_dev(dev);
- pnp_activate_dev(dev);
- if (quirk_smc_fir_enabled(dev)) {
- dev_err(&dev->dev, "responds at SIR 0x%lx, FIR 0x%lx\n",
- (unsigned long)pnp_port_start(dev, 0),
- (unsigned long)pnp_port_start(dev, 1));
- return;
- }
-
- /*
- * The Toshiba Portege 4000 _CRS reports the FIR region first,
- * followed by the SIR region. The BIOS will configure the bridge,
- * but only if we call _SRS with SIR first, then FIR. It also
- * reports the IRQ as active high, when it is really active low.
- */
- dev_err(&dev->dev, "not responding at SIR 0x%lx, FIR 0x%lx; "
- "swapping SIR/FIR and reconfiguring\n",
- (unsigned long)pnp_port_start(dev, 0),
- (unsigned long)pnp_port_start(dev, 1));
-
- /*
- * Clear IORESOURCE_AUTO so pnp_activate_dev() doesn't reassign
- * these resources any more.
- */
- fir = dev->res.port_resource[0];
- sir = dev->res.port_resource[1];
- fir.flags &= ~IORESOURCE_AUTO;
- sir.flags &= ~IORESOURCE_AUTO;
-
- irq = dev->res.irq_resource[0];
- irq.flags &= ~IORESOURCE_AUTO;
- irq.flags &= ~IORESOURCE_BITS;
- irq.flags |= IORESOURCE_IRQ_LOWEDGE;
-
- pnp_disable_dev(dev);
- dev->res.port_resource[0] = sir;
- dev->res.port_resource[1] = fir;
- dev->res.irq_resource[0] = irq;
- pnp_activate_dev(dev);
-
- if (quirk_smc_fir_enabled(dev)) {
- dev_err(&dev->dev, "responds at SIR 0x%lx, FIR 0x%lx\n",
- (unsigned long)pnp_port_start(dev, 0),
- (unsigned long)pnp_port_start(dev, 1));
- return;
- }
-
- dev_err(&dev->dev, "giving up; try \"smsc-ircc2.nopnp\" and "
- "email bjorn.helgaas@xxxxxx\n");
-}
-
/*
* PnP Quirks
* Cards or devices that need some tweaking due to incomplete resource info
@@ -229,7 +127,6 @@
{"CTL0043", quirk_sb16audio_resources},
{"CTL0044", quirk_sb16audio_resources},
{"CTL0045", quirk_sb16audio_resources},
- {"SMCf010", quirk_smc_enable},
{""}
};

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/