[PATCH pata-2.6 fix] hpt366: use correct enablebits for HPT36x

From: Sergei Shtylyov
Date: Fri Jun 29 2007 - 16:02:59 EST


The HPT36x chips finally turned out to have the channel enable bits -- however,
badly implemented. Make use of them despite it's probably only going to burden
the driver's code -- assuming both channels are always enabled by the HighPoint
BIOS anyway...

Signed-off-by: Sergei Shtylyov <sshtylyov@xxxxxxxxxxxxx>

---
Michal, Linas, please verify the patch... :-)

drivers/ide/pci/hpt366.c | 20 +++++++++++++++-----
1 files changed, 15 insertions(+), 5 deletions(-)

Index: linux-2.6/drivers/ide/pci/hpt366.c
===================================================================
--- linux-2.6.orig/drivers/ide/pci/hpt366.c
+++ linux-2.6/drivers/ide/pci/hpt366.c
@@ -1,5 +1,5 @@
/*
- * linux/drivers/ide/pci/hpt366.c Version 1.05 Jun 26, 2007
+ * linux/drivers/ide/pci/hpt366.c Version 1.06 Jun 27, 2007
*
* Copyright (C) 1999-2003 Andre Hedrick <andre@xxxxxxxxxxxxx>
* Portions Copyright (C) 2001 Sun Microsystems, Inc.
@@ -1514,18 +1514,28 @@ static int __devinit init_setup_hpt366(s
goto init_single;

/*
- * HPT36x chips are single channel and
- * do not seem to have the channel enable bit...
+ * HPT36x chips have one channel per function and have
+ * both channel enable bits located differently and visible
+ * to both functions -- really stupid design decision... :-(
+ * Bit 4 is for the primary channel, bit 5 for the secondary.
*/
d->channels = 1;
- d->enablebits[0].reg = 0;
+ d->enablebits[0].mask = d->enablebits[0].val = 0x10;

if ((dev2 = pci_get_slot(dev->bus, dev->devfn + 1)) != NULL) {
- u8 pin1 = 0, pin2 = 0;
+ u8 mcr1 = 0, pin1 = 0, pin2 = 0;
int ret;

pci_set_drvdata(dev2, info[rev]);

+ /*
+ * Now we'll have to force both channels enabled if
+ * at least one of them has been enabled by BIOS...
+ */
+ pci_read_config_byte(dev, 0x50, &mcr1);
+ if (mcr1 & 0x30)
+ pci_write_config_byte(dev, 0x50, mcr1 | 0x30);
+
pci_read_config_byte(dev, PCI_INTERRUPT_PIN, &pin1);
pci_read_config_byte(dev2, PCI_INTERRUPT_PIN, &pin2);
if (pin1 != pin2 && dev->irq == dev2->irq) {

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/