Re: PCI riser cards and PCI irq routing, etc

[Krzysztof Halasa]

Udo van den Heuvel <udovdh@xxxxxxxxx> writes:

> FYI: My situation is a VIA Epia EN12000 with a TranquilPC dual PCI riser
> where only the Device Number can be changed.

With jumpers?

> So IRQ 16 and 20. But when using the stock 2.6.20 kernel there is no
> communication with the DVB-T card (the frontend), so there is no
> /dev/dvb/* entry. This points to an IRQ problem.
>
> How can I find out the actual IRQ that the card is using?

I would remove the PCI cards and then the riser card and check INT
routing with a multimeter.
Perhaps a task for someone used to stuff like that.

> I set the BIOS for 'PnP OS installed'. Should I change that?

Most drivers already enable devices so it probably doesn't matter.
I would check it, though.
-- 
Krzysztof Halasa
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/