Re: [PATCH] [MMC] Use own work queue

[pHilipp Zabel]

Hi,

On 10/1/06, Pierre Ossman <drzeus@xxxxxxxxx> wrote:
> The MMC layer uses the standard work queue for doing card detection. As
> this queue is shared with other crucial subsystems, the effects of a long
> (and perhaps buggy) detection can cause the system to be unusable. E.g. the
> keyboard stops working while the detection routine is running.
>
> The solution is to add a specific mmc work queue to run the detection code
> in. This is similar to how other subsystems handle detection (a full
> kernel thread is the most common theme).
>
> Signed-off-by: Pierre Ossman <drzeus@xxxxxxxxx>

This patch makes pxamci stop working for me on a HTC Magician (PXA272).
Switching from 2.6.18 to 2.6.19-rc1 I got a kernel panic:

mmc0: clock 0Hz busmode 1 powermode 0 cs 0  Vdd 0 width 0
PXAMCI: clkrt = 0 cmdat = 0
VFS: Cannot open root device "mmcblk0p2" or unknown-block(0,0)
Please append a correct "root=" boot option
Kernel panic - not syncing: VFS: Unable to mount root fs on unknown-block(0,0)

After removing this patch from 2.6.19-rc1, everything is working again.
Are there any changes to pxamci.c needed to be compatible with it?

regards
Philipp
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/