[patch 04/10] [TULIP] Flush MMIO writes in reset sequence

[Valerie Henson]

From: Grant Grundler <grundler@xxxxxxxxxxxxxxxx>

The obvious safe registers to read is one from PCI config space.

Signed-off-by: Grant Grundler <grundler@xxxxxxxxxxxxxxxx>
Signed-off-by: Kyle McMartin <kyle@xxxxxxxxxxxxxxxx>
Signed-off-by: Valerie Henson <val_henson@xxxxxxxxxxxxxxx>
Signed-off-by: Jeff Garzik <jeff@xxxxxxxxxx>

---
 drivers/net/tulip/tulip_core.c |    2 ++
 1 files changed, 2 insertions(+)

--- linux-2.6.18-rc4-mm1.orig/drivers/net/tulip/tulip_core.c
+++ linux-2.6.18-rc4-mm1/drivers/net/tulip/tulip_core.c
@@ -295,12 +295,14 @@ static void tulip_up(struct net_device *
 
 	/* Reset the chip, holding bit 0 set at least 50 PCI cycles. */
 	iowrite32(0x00000001, ioaddr + CSR0);
+	pci_read_config_dword(tp->pdev, PCI_COMMAND, &i);  /* flush write */
 	udelay(100);
 
 	/* Deassert reset.
 	   Wait the specified 50 PCI cycles after a reset by initializing
 	   Tx and Rx queues and the address filter list. */
 	iowrite32(tp->csr0, ioaddr + CSR0);
+	pci_read_config_dword(tp->pdev, PCI_COMMAND, &i);  /* flush write */
 	udelay(100);
 
 	if (tulip_debug > 1)

--
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/