Re: [PATCH] pcnet32 driver NAPI support

[Don Fry]

On Wed, Jun 07, 2006 at 12:52:25PM -0400, Lennart Sorensen wrote:
> I have added NAPI support to the pcnet32 driver.  This has greatly
> improved the responsiveness on my systems (geode GX1 266MHz) when under
> heavy network load.  Without this change the system would become
> unresponsive due to interrupts when flooded with traffic, and eventually
> the watchdog would reboot the system due to the watchdog daemon being
> starved for cpu time.  With the patch the system is still useable on a
> serial console, although very slow.  Network throughput is also higher
> since more time is spend processing packets and getting them sent out,
> instead of only spending time acknowledging interrupts from incoming
> packets.
> 
> Now having never actually done a patch submission to the kernel before,
> I will try and see if I can do it right.
> 
> The patch adds a PCNET32_NAPI config option to drivers/net/Kconfig, and
> the appropriate code to support the option to drivers/net/pcnet32.c and
> has been tested on many of my systems (allthough they are allmost all
> identical, and require some extra patches to pcnet32 due to not having
> an EEPROM installed), and on an AT-2700TX.
> 
> I have made a diff against 2.6.16.20 and 2.6.17-rc6.
> 
> Comments would be very welcome.

I am also working on a NAPI version of the pcnet32 driver for many of
the same reasons, and will compare what you have with my own
implementation.  I probably won't be able to do much until Friday.  

Just a couple of comments.  I am adding netdev@xxxxxxxxxxxxxxx to the cc
list, as most network driver discussion is done here rather than lkml.
linux-kernel (and linux-net) should be deleted in future replies.

The 2.6.17-rc6 would be the correct source to patch against.  Since this
is an enhancement it will not come out till 2.6.18.

I would not change the driver name from pcnet32 to pcnet32napi, but I
would changes the version from 1.32 to 1.33NAPI or something like that.

Some areas of concern that you may have addressed already, I have not
scanned your changes yet, are what happens if the ring size is changed
without bringing down the interface (via ethtool), or if the loopback
test is run in a similar fashion, or a tx timeout occurs.

The lp->lock MUST be held whenever accessing the csr or bcr registers as
this is a multi-step process, and has been the source of problems in the
past.  Even on UP systems.

> 
> Signed-off-by: Len Sorensen <lsorense@xxxxxxxxxxxxxxxxxxx>
> 
> Len Sorensen

-- 
Don Fry
brazilnut@xxxxxxxxxx
-
To unsubscribe from this list: send the line "unsubscribe linux-net" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html