Michal Semler <cijoml@xxxxxxxx> wrote:Michael-
This is what I gets into dmesg:
Linux video capture interface: v1.00
bttv: driver version 0.9.15 loaded
bttv: using 8 buffers with 2080k (520 pages) each for capture
bttv: Bt8xx card found (0).
ACPI: PCI Interrupt 0000:01:0b.0[A] -> Link [LNKH] -> GSI 9 (level, low) -> IRQ 9
bttv0: Bt878 (rev 17) at 0000:01:0b.0, irq: 9, latency: 32, mmio: 0xb69fe000
bttv0: using: ProVideo PV951 [card=42,insmod option]
bttv0: gpio: en=00000000, out=00000000 in=00ffffff [init]
bttv0: using tuner=1
bttv0: i2c: checking for TDA9875 @ 0xb0... not found
bttv0: i2c: checking for TDA7432 @ 0x8a... not found
tvaudio: TV audio decoder + audio/video mux driver
tvaudio: known chips: tda9840,tda9873h,tda9874h/a,tda9850,tda9855,tea6300,tea6320,tea6420,tda8425,pic16c54 (PV951),ta8874z
tvaudio: found pic16c54 (PV951) @ 0x96
bttv0: i2c: checking for TDA9887 @ 0x86... not found
tuner: Unknown parameter `type'
bttv0: registered device video0
bttv0: registered device vbi0
bttv0: registered device radio0
bttv0: PLL: 28636363 => 35468950 .. ok
ACPI: PCI Interrupt Link [LNKB] enabled at IRQ 10
PCI: setting IRQ 10 as level-triggered
ACPI: PCI Interrupt 0000:01:0c.0[A] -> Link [LNKB] -> GSI 10 (level, low) -> IRQ 10
(cc the v4l list)
The above is with 2.6.13-rc4. 2.6.11 was OK.