[patch] QLA2xxx FW_LOADER Kconfig issue results in undefined symbols

[Erik Jacobson]

I hit a small problem (first observed in 2.6.13-rc3-mm1) that resulted in
my kernels no longer building because of undefined references to 
request_firmware and release_firmware.

After a little research, I found that the QLA stuff requires CONFIG_FW_LOADER.

I was using the sn2_defconfig as a starting point for my config file. 
This config file compiles some of the QLA2xxx drivers statically.
By default, CONFIG_FW_LOADER is set to "m" and not "y".

So this small change should ensure CONFIG_FW_LOADER is set properly.

Perhaps there are better ways to do this?

Signed-off-by: Erik Jacobson <erikj@xxxxxxx>

---

 Kconfig |    1 +
 1 files changed, 1 insertion(+)


diff -Naru 2.6-akpm-rc-mm-orig/drivers/scsi/qla2xxx/Kconfig 2.6-akpm-rc-mm/drivers/scsi/qla2xxx/Kconfig
--- 2.6-akpm-rc-mm-orig/drivers/scsi/qla2xxx/Kconfig	2005-07-15 10:58:54.316985000 -0500
+++ 2.6-akpm-rc-mm/drivers/scsi/qla2xxx/Kconfig	2005-07-18 14:03:37.888758336 -0500
@@ -3,6 +3,7 @@
 	default (SCSI && PCI)
 	depends on SCSI && PCI
 	select SCSI_FC_ATTRS
+	select FW_LOADER
 
 config SCSI_QLA21XX
 	tristate "QLogic ISP2100 host adapter family support"

--
Erik Jacobson - Linux System Software - Silicon Graphics - Eagan, Minnesota
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/