Re: 2.6.12-rc5-git6 mis-counted ide interfaces

[Martin MOKREJŠ]

Bartlomiej Zolnierkiewicz wrote:
> On 6/2/05, Martin MOKREJŠ <mmokrejs@xxxxxxxxxxxxxxxxxxxxxx> wrote:
>
> > Hi,
> >  I get the following when I boot my PIIX computer (Asus P4C800E-Deluxe):
> >
> >
> > Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
> > ide: Assuming 66MHz system bus speed for PIO modes
> > ICH5: IDE controller at PCI slot 0000:00:1f.1
> > PCI: Enabling device 0000:00:1f.1 (0005 -> 0007)
> > ACPI: PCI Interrupt 0000:00:1f.1[A] -> GSI 18 (level, low) -> IRQ 18
> > ICH5: chipset revision 2
> > ICH5: not 100% native mode: will probe irqs later
> >    ide0: BM-DMA at 0xfc00-0xfc07, BIOS settings: hda:DMA, hdb:pio
> >    ide1: BM-DMA at 0xfc08-0xfc0f, BIOS settings: hdc:pio, hdd:pio
> > Probing IDE interface ide0...
> > hda: SONY DVD RW DRU-510A, ATAPI CD/DVD-ROM drive
> > ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
> > Probing IDE interface ide1...
> > ----------------------^^^^ ide0 I believe
>
>
> ide0 is 3 lines above
>
>
> > Probing IDE interface ide1...
> > Probing IDE interface ide2...
> > Probing IDE interface ide3...
> > Probing IDE interface ide4...
> > Probing IDE interface ide5...
>
>
> If you have CONFIG_IDE_GENERIC=y in your config everything is fine
> (IDE driver simply tries to probe legacy ports).

Yes, I do, I was just fooled why I see twice probe for ide1. So you say the "extra"
probe for ide1 is because of CONFIG_IDE_GENERIC=y?

The next ide port are two SATA port and two SATA-RAID ports, btw.
Martin
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/