[no subject]

From: Kai OM
Date: Thu Jun 03 2004 - 21:32:30 EST


Hello, list.

I'm hoping someone here can shed some insight into just a weird issue I'm
having with 2.6.6-rc1 - or, if it's a bug, hoping the right person hears
about it so it can get fixed.

Note that I've been able to boot into other 2.6 kernels in the past, even
very recent ones, so it's something related to this specific version, I'm
convinced. I've not installed any new hardware, or done anything drastic
to the kernel config; in fact, I'm pretty sure the pertinent bits of the
kernel config are identical to the configs I used in older kernels, which
didn't cause the problem I'm outlining.

Anyway, here's my hardware:
Athlon-XP 2500
1024 MB DDR RAM
A7N8X 2.0
Onboard sound and ethernet
Geforce FX 5900
LSIU160 SCSI controller
Onboard SiI3112 SATA controller
WD Raptor 10K 70 GB HDD
Atlas 10K II SCSI HDD

Here's my issue:

I compiled 2.6.6-rc1, installed modules, updated the bootloader, then
rebooted... when I tried to load the new kernel, here's the screen output
I was able to record(I had to write it on paper, so couldn't get
everything; also, this might have some superficial inaccuracies)

sym0:<1010-33> rev 0x1 PCI 0000:01:0a.0 irq 16
sym0: using 64 bit DMA addressing
sym0: Symbios NVRAM ID7, fast 80, LVD, parity checking
sym0: Open drain IRQ driver, using on-chip SRAM
sym0: using LOAD/STORE based firmware
sym0: handling phase mismatch from SCRIPTS
sym0: scan at boot disabled for targets 0 1 2 3 4 5 6 7 8 9 10 11 12 13
14 15
sym0: scan for LUNS disabled for targets 0 1 2 3 4 5 6 7 8 9 10 11 12 13
14 15
scsi0: Sym-2.1.18j
Vendor: QUANTUM Model: ATLAS10K2-TY734J
Type: Direct-access ANSI SCSI revision: 03
scsi(0:0:0:0): Beginning Domain Validation
sym0:0:Wide asynchronous
sym0:0: ABORT operation started
sym0:0: ABORT operation timed out
sym0:0: DEVICE RESET operation started
sym0:0: DEVICE RESET operation completed
sym0: SCSI bus has been reset
sym0:0: ABORT operation started
sym0:0: ABORT operation timed out
sym0:0: DEVICE RESET operation started
sym0:0: DEVICE RESET operation completed
sym0: SCSI bus has been reset

After this, it just hangs for about three minutes, then the screen goes
blank, and the system remains unresponsive. Ctrl-Alt-Del does nothing. I
had to power off.

I was able to use the Gentoo 2.6.5 kernel just fine(aside from some
lockup bugs caused by an issue with my nForce2 motherboard - on that
subject, can anyone tell me if the patches remedying that have been
implimented?), and I have been able to use the 2.6.3 kernel as well, so
whatever changed is very recent, I am sure. Other people on the Gentoo
forums confirm this as an issue; I can prolly dig up links if necessary.

Attached are my kernel configs for the Gentoo 2.6.5-rc1 and vanilla
2.6.6-rc1 kernels, as well as the output from lspci, just in case that's
needed.

Thanks in advance for any help.

Attachment: kernel.config-2.6.6-rc1
Description: application/unknown

Attachment: kernel.config-Gentoo-2.6.5
Description: application/unknown

00:00.0 Host bridge: nVidia Corporation nForce2 AGP (different version?) (rev c1)
Subsystem: Asustek Computer, Inc.: Unknown device 80ac
Flags: bus master, 66Mhz, fast devsel, latency 0
Memory at d0000000 (32-bit, prefetchable) [size=128M]
Capabilities: [40] AGP version 3.0
Capabilities: [60] #08 [2001]

00:00.1 RAM memory: nVidia Corporation nForce2 Memory Controller 1 (rev c1)
Subsystem: Asustek Computer, Inc.: Unknown device 80ac
Flags: 66Mhz, fast devsel

00:00.2 RAM memory: nVidia Corporation nForce2 Memory Controller 4 (rev c1)
Subsystem: Asustek Computer, Inc.: Unknown device 80ac
Flags: 66Mhz, fast devsel

00:00.3 RAM memory: nVidia Corporation nForce2 Memory Controller 3 (rev c1)
Subsystem: Asustek Computer, Inc.: Unknown device 80ac
Flags: 66Mhz, fast devsel

00:00.4 RAM memory: nVidia Corporation nForce2 Memory Controller 2 (rev c1)
Subsystem: Asustek Computer, Inc.: Unknown device 80ac
Flags: 66Mhz, fast devsel

00:00.5 RAM memory: nVidia Corporation nForce2 Memory Controller 5 (rev c1)
Subsystem: Asustek Computer, Inc.: Unknown device 80ac
Flags: 66Mhz, fast devsel

00:01.0 ISA bridge: nVidia Corporation nForce2 ISA Bridge (rev a4)
Subsystem: Asustek Computer, Inc. A7N8X Mainboard
Flags: bus master, 66Mhz, fast devsel, latency 0
Capabilities: [48] #08 [01e1]

00:01.1 SMBus: nVidia Corporation nForce2 SMBus (MCP) (rev a2)
Subsystem: Asustek Computer, Inc.: Unknown device 0c11
Flags: 66Mhz, fast devsel, IRQ 5
I/O ports at ec00 [size=32]
Capabilities: [44] Power Management version 2

00:02.0 USB Controller: nVidia Corporation nForce2 USB Controller (rev a4) (prog-if 10 [OHCI])
Subsystem: Asustek Computer, Inc. A7N8X Mainboard
Flags: bus master, 66Mhz, fast devsel, latency 0, IRQ 12
Memory at e4080000 (32-bit, non-prefetchable) [size=4K]
Capabilities: [44] Power Management version 2

00:02.1 USB Controller: nVidia Corporation nForce2 USB Controller (rev a4) (prog-if 10 [OHCI])
Subsystem: Asustek Computer, Inc. A7N8X Mainboard
Flags: bus master, 66Mhz, fast devsel, latency 0, IRQ 11
Memory at e4082000 (32-bit, non-prefetchable) [size=4K]
Capabilities: [44] Power Management version 2

00:02.2 USB Controller: nVidia Corporation nForce2 USB Controller (rev a4) (prog-if 20 [EHCI])
Subsystem: Asustek Computer, Inc. A7N8X Mainboard
Flags: bus master, 66Mhz, fast devsel, latency 0, IRQ 3
Memory at e4083000 (32-bit, non-prefetchable) [size=256]
Capabilities: [44] #0a [2080]
Capabilities: [80] Power Management version 2

00:04.0 Ethernet controller: nVidia Corporation nForce2 Ethernet Controller (rev a1)
Subsystem: Asustek Computer, Inc.: Unknown device 80a7
Flags: bus master, 66Mhz, fast devsel, latency 0, IRQ 3
Memory at e4084000 (32-bit, non-prefetchable) [size=4K]
I/O ports at e000 [size=8]
Capabilities: [44] Power Management version 2

00:05.0 Multimedia audio controller: nVidia Corporation nForce MultiMedia audio [Via VT82C686B] (rev a2)
Subsystem: Asustek Computer, Inc.: Unknown device 0c11
Flags: bus master, 66Mhz, fast devsel, latency 0, IRQ 12
Memory at e4000000 (32-bit, non-prefetchable) [size=512K]
Capabilities: [44] Power Management version 2

00:06.0 Multimedia audio controller: nVidia Corporation nForce2 AC97 Audio Controler (MCP) (rev a1)
Subsystem: Asustek Computer, Inc.: Unknown device 8095
Flags: bus master, 66Mhz, fast devsel, latency 0, IRQ 5
I/O ports at e400 [size=256]
I/O ports at e800 [size=128]
Memory at e4081000 (32-bit, non-prefetchable) [size=4K]
Capabilities: [44] Power Management version 2

00:08.0 PCI bridge: nVidia Corporation nForce2 External PCI Bridge (rev a3) (prog-if 00 [Normal decode])
Flags: bus master, 66Mhz, fast devsel, latency 0
Bus: primary=00, secondary=01, subordinate=01, sec-latency=32
I/O behind bridge: 0000c000-0000dfff
Memory behind bridge: e2000000-e3ffffff

00:09.0 IDE interface: nVidia Corporation nForce2 IDE (rev a2) (prog-if 8a [Master SecP PriP])
Subsystem: Asustek Computer, Inc.: Unknown device 0c11
Flags: bus master, 66Mhz, fast devsel, latency 0
I/O ports at f000 [size=16]
Capabilities: [44] Power Management version 2

00:1e.0 PCI bridge: nVidia Corporation nForce2 AGP (rev c1) (prog-if 00 [Normal decode])
Flags: bus master, 66Mhz, medium devsel, latency 32
Bus: primary=00, secondary=02, subordinate=02, sec-latency=32
Memory behind bridge: e0000000-e1ffffff
Prefetchable memory behind bridge: d8000000-dfffffff

01:08.0 Communication controller: Intel Corp. 536EP Data Fax Modem
Subsystem: Intel Corp.: Unknown device 1000
Flags: bus master, medium devsel, latency 32, IRQ 5
Memory at e3000000 (32-bit, non-prefetchable) [size=4M]
Capabilities: [e0] Power Management version 2

01:0a.0 SCSI storage controller: LSI Logic / Symbios Logic 53c1010 Ultra3 SCSI Adapter (rev 01)
Subsystem: LSI Logic / Symbios Logic: Unknown device 1030
Flags: bus master, medium devsel, latency 72, IRQ 12
I/O ports at c000 [size=256]
Memory at e3405000 (64-bit, non-prefetchable) [size=1K]
Memory at e3400000 (64-bit, non-prefetchable) [size=8K]
Expansion ROM at <unassigned> [disabled] [size=128K]
Capabilities: [40] Power Management version 2

01:0a.1 SCSI storage controller: LSI Logic / Symbios Logic 53c1010 Ultra3 SCSI Adapter (rev 01)
Subsystem: LSI Logic / Symbios Logic: Unknown device 1030
Flags: bus master, medium devsel, latency 32, IRQ 11
I/O ports at c400 [size=256]
Memory at e3404000 (64-bit, non-prefetchable) [size=1K]
Memory at e3402000 (64-bit, non-prefetchable) [size=8K]
Expansion ROM at <unassigned> [disabled] [size=128K]
Capabilities: [40] Power Management version 2

01:0b.0 RAID bus controller: CMD Technology Inc Silicon Image SiI 3112 SATARaid Controller (rev 02)
Subsystem: CMD Technology Inc: Unknown device 6112
Flags: bus master, 66Mhz, medium devsel, latency 32, IRQ 5
I/O ports at c800 [size=8]
I/O ports at cc00 [size=4]
I/O ports at d000 [size=8]
I/O ports at d400 [size=4]
I/O ports at d800 [size=16]
Memory at e3406000 (32-bit, non-prefetchable) [size=512]
Expansion ROM at <unassigned> [disabled] [size=512K]
Capabilities: [60] Power Management version 2

02:00.0 VGA compatible controller: nVidia Corporation NV35 [GeForce FX 5900] (rev a1) (prog-if 00 [VGA])
Flags: bus master, 66Mhz, medium devsel, latency 32, IRQ 11
Memory at e0000000 (32-bit, non-prefetchable) [size=16M]
Memory at d8000000 (32-bit, prefetchable) [size=128M]
Expansion ROM at <unassigned> [disabled] [size=128K]
Capabilities: [60] Power Management version 2
Capabilities: [44] AGP version 3.0