Re: hdc: lost interrupt ide-cd: cmd 0x3 timed out with2.6.6-rc3-bk8

[Bob Gill]

>zero IDE changes in bk6 -> bk8 but a lot of ACPI / IRQ related

OK.  My APIC is a SiS961.  
I can't send data from 2.6.6-rc3-bk8, but from 2.6.6-rc3-bk6,
/proc/acpi gives:
(/proc/acpi/processor/CPU0)
processor id:            0
acpi id:                 0
bus mastering control:   yes
power management:        no
throttling control:      no
limit interface:         no
<not supported>
active state:            C1
default state:           C1
bus master activity:     00000000
states:
   *C1:                  promotion[--] demotion[--] latency[000]
usage[00000000]
    C2:                  <not supported>
    C3:                  <not supported>
<not supported>

cat /proc/acpi/sleep shows:
S0 S1 S4 S5
cat /proc/ide/sis shows:
SiS 5513 Ultra 100 chipset
--------------- Primary Channel ---------------- Secondary Channel
-------------
Channel Status: On                               On
Operation Mode: Compatible                       Compatible
Cable Type:     80 pins                          80 pins
Prefetch Count: 512                              512
Drive 0:        Postwrite Enabled                Postwrite Disabled
                Prefetch  Enabled                Prefetch  Disabled
                UDMA Enabled                     UDMA Enabled
                UDMA Cycle Time    3 CLK         UDMA Cycle Time    6
CLK
                Data Active Time   3 PCICLK      Data Active Time   3
PCICLK
                Data Recovery Time 1 PCICLK      Data Recovery Time 1
PCICLK
Drive 1:        Postwrite Enabled                Postwrite Disabled
                Prefetch  Enabled                Prefetch  Disabled
                UDMA Enabled                     UDMA Disabled
                UDMA Cycle Time    2 CLK         UDMA Cycle Time   
Reserved
                Data Active Time   3 PCICLK      Data Active Time   3
PCICLK
                Data Recovery Time 1 PCICLK      Data Recovery Time 3
PCICLK


... I don't know if any of this is helpful.  The IRQ and IO address
assignments (sent with my first email) are from 2.6.6-rc3-bk6.  

Thanks,
Bob

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/