Re: bcm5700 driver at 100Mbit? tg3 doesn't do 100Mbit - 2.6.4-mm1

[Lech Szychowski]

> > tg3.ko loads, network starts up. Can't connect to 100Mbit network 
> > switch. The bcm5700 driver in ths SuSE kraxel 2.6.3 kernel works. The 
> > tg3  is supposed to be a replacement for bcm5700 I believe.

Works for me (Dell Latitude D600), both for "NIC to switch"...

===
Mar 12 16:20:37 y kernel: Linux version 2.6.4-mm1 (lech7@y) (gcc version 3.3.3) #1 Thu Mar 11 14:16:54 CET 2004
[...]
Mar 12 16:20:37 y kernel: eth0: Tigon3 [partno(BCM95702A20) rev 1002 PHY(5703)] (PCI:33MHz:32-bit) 10/100/1000BaseT Ethernet 00:0d:56:7b:d8:9d
[...]
Mar 12 16:20:39 y kernel: tg3: eth0: Link is up at 100 Mbps, half duplex.
Mar 12 16:20:39 y kernel: tg3: eth0: Flow control is off for TX and off for RX.
===

...and "NIC to NIC" mode:

===
Mar 14 03:43:08 y kernel: Linux version 2.6.4-mm1 (lech7@y) (gcc version 3.3.3) #1 Thu Mar 11 14:16:54 CET 2004
[...]
Mar 14 03:43:08 y kernel: eth0: Tigon3 [partno(BCM95702A20) rev 1002 PHY(5703)] (PCI:33MHz:32-bit) 10/100/1000BaseT Ethernet 00:0d:56:7b:d8:9d
[...]
Mar 14 03:43:10 y kernel: tg3: eth0: Link is up at 100 Mbps, full duplex.
Mar 14 03:43:10 y kernel: tg3: eth0: Flow control is off for TX and off for RX.
===

-- 
	Leszek.

-- lech7@xxxxxx 2:480/33.7          -- REAL programmers use INTEGERS --
-- speaking just for myself...
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/