Re: Realtek network card

[Micha Feigin]

On Wed, 2003-08-13 at 14:30, Stephan von Krawczynski wrote:
> Hello all,
> 
> does anybody know how to make the below work (neiter 2.2.25 nor 2.4.21 seem to recognise it):
> 

Try modprobe 8139too
(if you are using a precompiled kernel you should have the driver its
quite standard, otherwise make sure that you are building it).

> lspci --vv:
> 
> 00:08.0 Ethernet controller: Realtek Semiconductor Co., Ltd.: Unknown device 8131 (rev 10)
> 	Subsystem: Realtek Semiconductor Co., Ltd.: Unknown device 8139
> 	Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
> 	Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
> 	Latency: 32 min, 64 max, 32 set
> 	Interrupt: pin A routed to IRQ 11
> 	Region 0: I/O ports at e800
> 	Region 1: Memory at ee000000 (32-bit, non-prefetchable)
> 	Capabilities: [50] Power Management version 2
> 		Flags: PMEClk- AuxPwr- DSI- D1+ D2+ PME-
> 		Status: D0 PME-Enable- DSel=0 DScale=0 PME-
> 
> 
> Regards,
> Stephan
> -
> To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
> the body of a message to majordomo@xxxxxxxxxxxxxxx
> More majordomo info at  http://vger.kernel.org/majordomo-info.html
> Please read the FAQ at  http://www.tux.org/lkml/
-- 
Micha Feigin
michf@xxxxxxxxxxxxxx

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/