On 13 Nov 2002, Freaky wrote:
> I couldn't install slackware at all, even with my home compiled kernel.
> It just doesn't recognize the /dev/ataraid/d?p? drives and tells me
> there are no disks with ext2 filesystems when I try to start setup.
You can simply mount /dev/ataraid/d?p? on /mnt and start the slackware
installation setup script skipping the selection of the target, the swap
and the lilo configuration; after istallation is completed, you can edit
/etc/fstab and /etc/lilo.conf as you whish.
> You need the ataraid drivers for the pdc don't you?
I compiled the kernel with PDC202XX driver, with ataraid and with FastTrak
ataraid driver.
> How did you compile pdc without ataraid?
I tryed to compile pdc202xx and not ataraid to try to use software raid.
Is this the answer you were lookig for?
In all the cases my pdc20276 hangs after about half a gigabyte written
into any disk.
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Fri Nov 15 2002 - 22:00:29 EST