Hi Guys
I'm working for 4 days on a parallel port misbehavior problem without having
any sucess. I have to control a device with SPP mode using a pcchips M810, a
Duron processor and a kernel 2.4.19.
So I made the following simple code :
--
#include <asm/io.h> //i've tried <sys/io.h> too
int main ()
{
ioperm( 0x378, 3, 1);
outb (0x01, 0x378 );
ioperm (0x378, 3, 0);
return 0;
}
--
And copiled with "gcc -O2 test.c -o test; ./test". running it as superuser
the result should be a "1" logic on pin "2" of parallel port.
Ok it is correct except for this motherboard, it works on Soyo+K6,
Gigabyte+Athlon, i810+Celeron, etc. But it doesn't for M810+Duron.
I verified the BIOS setup, changed the kernel source for 2.2.20, changed the
motherboard for M812, recompiled and recompiled the kernel, changed the
distro from Debian/Woody to Debian/Testing. None of this worked.
So I tried to install Win95 and make it using a assembler code ... It worked.
The next thing i've done was start making a kernel module.... it worked for
Gigabyte+Athlon, i810+Celeron, Soyo+K6 and a old PC-Chips board with K6
processor....but nothing happened for the M810+Duron board though.
So I thought it should be a problem with outb call, so I made a module using
assembler instead outb call, it was compiled with success and was installed.
The requested i/o region was reserved with success but didn't work with
M810+Duron. Though It worked with Gigabyte+Athlon and Soyo+K6 again.
So i get the old code (as i listed above) and after testing it with success
again in the Soyo+K6 board i compiled it and linked the program statically. i
brought the executable to the M810+Duron and it didn't work again... though
it always runs without any errors the signals are not present on the parallel
port.
I tried to access the parallel port through /dev/ports using lseek to get the
0x378 address position... and the result was the same... nothing for
M810+Duron
I don't know any more to do, and I'm wondered if anyone here can help me. I
can't believe it will not work on this motherboard if the parallel works
perfectly. If anyone have any information about this parallel port on this
motherboard, any code or any related knowlegment and like to share It would
be a lot appreciated.
Thanks.
Fernando.
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Thu Nov 07 2002 - 22:00:47 EST