On Tue, 23 Jul 2002, Michael De Nil wrote:
> Hey
>
> I have bought an SMC 1255TX-card.
> In the manual is said that I should use the Tulip-driver.
> I was able to load the module tulip.o from kernel 2.4.19-pre10, but when
I
> start my network (/etc/init.d/networking start) on my debian-machine,
the
> screen starts flashing the message:
> Eth0: (i) System Error occured (0)
> with i = number increasing by 1
>
> I didn't see any of this in the changelog up to rc3..
It looked like it was sharing IRQ with another piece of hardware, when I
remove all other hardware, the card runs just fine.
The insmod-msg I recieved with shared IRQ:
...
PCI: Found IRQ 5 for device 00:14.0
PCI Sharing IRQ 5 with 00:13.0
eth0: SMC EZ Card 10/100 rev 17 at 0xc800, 00:04:E2:3D:AB:52, IRQ 5.
Greetings
Michael
-----------------------------------------------------------------------
Michael De Nil -- michael@aerythmic.be
Linux LiSa 2.4.19-rc2 #1 vr jul 19 22:10:00 CEST 2002 i686
14:41:01 up 4 days, 3:56, 8 users, load average: 0.00, 0.00, 0.00
-----------------------------------------------------------------------
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Tue Jul 30 2002 - 14:00:15 EST