This is supposed to fix the misidentified names from
drivers/net/tulip/media.c, which previously printk'd "eth%d".
--- linus-2.5/drivers/net/tulip/media.c Wed Jun 5 10:02:45 2002
+++ thunder-2.5.20/drivers/net/tulip/media.c Fri Jun 7 11:39:06 2002
@@ -182,9 +182,9 @@
switch (mleaf->type) {
case 0: /* 21140 non-MII xcvr. */
if (tulip_debug > 1)
- printk(KERN_DEBUG "%s: Using a 21140 non-MII transceiver"
+ printk(KERN_DEBUG "tulip%d: Using a 21140 non-MII transceiver"
" with control setting %2.2x.\n",
- dev->name, p[1]);
+ dev->ifindex, p[1]);
dev->if_port = p[0];
if (startup)
outl(mtable->csr12dir | 0x100, ioaddr + CSR12);
@@ -205,15 +205,15 @@
struct medialeaf *rleaf = &mtable->mleaf[mtable->has_reset];
unsigned char *rst = rleaf->leafdata;
if (tulip_debug > 1)
- printk(KERN_DEBUG "%s: Resetting the transceiver.\n",
- dev->name);
+ printk(KERN_DEBUG "tulip%d: Resetting the transceiver.\n",
+ dev->ifindex);
for (i = 0; i < rst[0]; i++)
outl(get_u16(rst + 1 + (i<<1)) << 16, ioaddr + CSR15);
}
if (tulip_debug > 1)
- printk(KERN_DEBUG "%s: 21143 non-MII %s transceiver control "
+ printk(KERN_DEBUG "tulip%d: 21143 non-MII %s transceiver control "
"%4.4x/%4.4x.\n",
- dev->name, medianame[dev->if_port], setup[0], setup[1]);
+ dev->ifindex, medianame[dev->if_port], setup[0], setup[1]);
if (p[0] & 0x40) { /* SIA (CSR13-15) setup values are provided. */
csr13val = setup[0];
csr14val = setup[1];
@@ -240,8 +240,8 @@
if (startup) outl(csr13val, ioaddr + CSR13);
}
if (tulip_debug > 1)
- printk(KERN_DEBUG "%s: Setting CSR15 to %8.8x/%8.8x.\n",
- dev->name, csr15dir, csr15val);
+ printk(KERN_DEBUG "tulip%d: Setting CSR15 to %8.8x/%8.8x.\n",
+ dev->ifindex, csr15dir, csr15val);
if (mleaf->type == 4)
new_csr6 = 0x82020000 | ((setup[2] & 0x71) << 18);
else
@@ -285,8 +285,8 @@
if (tp->mii_advertise == 0)
tp->mii_advertise = tp->advertising[phy_num];
if (tulip_debug > 1)
- printk(KERN_DEBUG "%s: Advertising %4.4x on MII %d.\n",
- dev->name, tp->mii_advertise, tp->phys[phy_num]);
+ printk(KERN_DEBUG "tulip%d: Advertising %4.4x on MII %d.\n",
+ dev->ifindex, tp->mii_advertise, tp->phys[phy_num]);
tulip_mdio_write(dev, tp->phys[phy_num], 4, tp->mii_advertise);
}
break;
@@ -303,8 +303,8 @@
struct medialeaf *rleaf = &mtable->mleaf[mtable->has_reset];
unsigned char *rst = rleaf->leafdata;
if (tulip_debug > 1)
- printk(KERN_DEBUG "%s: Resetting the transceiver.\n",
- dev->name);
+ printk(KERN_DEBUG "tulip%d: Resetting the transceiver.\n",
+ dev->ifindex);
for (i = 0; i < rst[0]; i++)
outl(get_u16(rst + 1 + (i<<1)) << 16, ioaddr + CSR15);
}
@@ -312,20 +312,20 @@
break;
}
default:
- printk(KERN_DEBUG "%s: Invalid media table selection %d.\n",
- dev->name, mleaf->type);
+ printk(KERN_DEBUG "tulip%d: Invalid media table selection %d.\n",
+ dev->ifindex, mleaf->type);
new_csr6 = 0x020E0000;
}
if (tulip_debug > 1)
- printk(KERN_DEBUG "%s: Using media type %s, CSR12 is %2.2x.\n",
- dev->name, medianame[dev->if_port],
+ printk(KERN_DEBUG "tulip%d: Using media type %s, CSR12 is %2.2x.\n",
+ dev->ifindex, medianame[dev->if_port],
inl(ioaddr + CSR12) & 0xff);
} else if (tp->chip_id == LC82C168) {
if (startup && ! tp->medialock)
dev->if_port = tp->mii_cnt ? 11 : 0;
if (tulip_debug > 1)
- printk(KERN_DEBUG "%s: PNIC PHY status is %3.3x, media %s.\n",
- dev->name, inl(ioaddr + 0xB8), medianame[dev->if_port]);
+ printk(KERN_DEBUG "tulip%d: PNIC PHY status is %3.3x, media %s.\n",
+ dev->ifindex, inl(ioaddr + 0xB8), medianame[dev->if_port]);
if (tp->mii_cnt) {
new_csr6 = 0x810C0000;
outl(0x0001, ioaddr + CSR15);
@@ -356,9 +356,9 @@
} else
new_csr6 = 0x038600000;
if (tulip_debug > 1)
- printk(KERN_DEBUG "%s: No media description table, assuming "
+ printk(KERN_DEBUG "tulip%d: No media description table, assuming "
"%s transceiver, CSR12 %2.2x.\n",
- dev->name, medianame[dev->if_port],
+ dev->ifindex, medianame[dev->if_port],
inl(ioaddr + CSR12));
}
@@ -380,16 +380,16 @@
bmsr = tulip_mdio_read(dev, tp->phys[0], MII_BMSR);
lpa = tulip_mdio_read(dev, tp->phys[0], MII_LPA);
if (tulip_debug > 1)
- printk(KERN_INFO "%s: MII status %4.4x, Link partner report "
- "%4.4x.\n", dev->name, bmsr, lpa);
+ printk(KERN_INFO "tulip%d: MII status %4.4x, Link partner report "
+ "%4.4x.\n", dev->ifindex, bmsr, lpa);
if (bmsr == 0xffff)
return -2;
if ((bmsr & BMSR_LSTATUS) == 0) {
int new_bmsr = tulip_mdio_read(dev, tp->phys[0], MII_BMSR);
if ((new_bmsr & BMSR_LSTATUS) == 0) {
if (tulip_debug > 1)
- printk(KERN_INFO "%s: No link beat on the MII interface,"
- " status %4.4x.\n", dev->name, new_bmsr);
+ printk(KERN_INFO "tulip%d: No link beat on the MII interface,"
+ " status %4.4x.\n", dev->ifindex, new_bmsr);
return -1;
}
}
@@ -408,9 +408,9 @@
tulip_restart_rxtx(tp);
if (tulip_debug > 0)
- printk(KERN_INFO "%s: Setting %s-duplex based on MII"
+ printk(KERN_INFO "tulip%d: Setting %s duplex based on MII"
"#%d link partner capability of %4.4x.\n",
- dev->name, tp->full_duplex ? "full" : "half",
+ dev->ifindex, tp->full_duplex ? "full" : "half",
tp->phys[0], lpa);
return 1;
}
-- Lightweight patch manager using pine. If you have any objections, tell me.- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Fri Jun 07 2002 - 22:00:30 EST