On Thu, Jul 19, 2001 at 01:23:40PM +0200, Ole Gjerde wrote:
> Hi,
> I've been trying to get this Adaptec 2100S RAID card to work. It works fine
> with the adaptec patch(the dpt_i2o driver), but I would really like to get
> it to work with the stock i2o driver. According to the messages I've seen
> so far this should work without any problems.
>
> However, when the kernel boots, it scans the bus, finds the card and starts
> the initializing and then it oopses.
>
Are you using i2o_block or i2o_scsi? i2o_scsi is broken, but some people
have gotten i2o_block to work.
Unfortunately, I'm also having problems with this card on a RAID1 array.
Basically, the install works fine, then if I run dselect update on Debian,
it'll get to Reading Package Lists...1%, then the drive freezes for several
seconds. I get the following message, and the controller starts beeping
(because the array is "degraded"), and the OS continues to work normally
(albeit the ear-pearcing beeping).
/dev/i2o/hda error: Failure communicating to device.
end_request: I/O error, dev 50:09 (i2o block), sector 4416
Alan, if you're following this, do you have any ideas?
-- Dwayne C. Litzenberger - dlitz@dlitz.net
This archive was generated by hypermail 2b29 : Mon Jul 23 2001 - 21:00:15 EST