Linux version 2.4.1-ac16 (root@super-babar) (gcc version egcs-2.91.66 19990314/Linux (egcs-1.1.2 release)) #2 Sat Feb 17 00:58:02 CET 2001
BIOS-provided physical RAM map:
 BIOS-e820: 000000000009fc00 @ 0000000000000000 (usable)
 BIOS-e820: 0000000000000400 @ 000000000009fc00 (reserved)
 BIOS-e820: 000000000000c000 @ 00000000000c0000 (reserved)
 BIOS-e820: 000000000feec000 @ 0000000000100000 (usable)
 BIOS-e820: 0000000000004000 @ 000000000ffec000 (reserved)
 BIOS-e820: 0000000000200000 @ 00000000ffe00000 (reserved)
On node 0 totalpages: 65516
zone(0): 4096 pages.
zone(1): 61420 pages.
zone(2): 0 pages.
Kernel command line: auto BOOT_IMAGE=linux2.4ac16 ro root=305 BOOT_FILE=/boot/vmlinuz-2.4.1-ac16
Initializing CPU#0
Detected 848.157 MHz processor.
Console: colour VGA+ 80x25
Calibrating delay loop... 1690.82 BogoMIPS
Memory: 255504k/262064k available (1016k kernel code, 6172k reserved, 388k data, 188k init, 0k highmem)
Dentry-cache hash table entries: 32768 (order: 6, 262144 bytes)
Buffer-cache hash table entries: 16384 (order: 4, 65536 bytes)
Page-cache hash table entries: 65536 (order: 6, 262144 bytes)
Inode-cache hash table entries: 16384 (order: 5, 131072 bytes)
CPU: Before vendor init, caps: 0383f9ff 00000000 00000000, vendor = 0
CPU: L1 I cache: 16K, L1 D cache: 16K
CPU: L2 cache: 256K
Intel machine check architecture supported.
Intel machine check reporting enabled on CPU#0.
CPU: After vendor init, caps: 0383f9ff 00000000 00000000 00000000
CPU: After generic, caps: 0383f9ff 00000000 00000000 00000000
CPU: Common caps: 0383f9ff 00000000 00000000 00000000
CPU: Intel Pentium III (Coppermine) stepping 06
Enabling fast FPU save and restore... done.
Enabling unmasked SIMD FPU exception support... done.
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
mtrr: v1.37 (20001109) Richard Gooch (rgooch@atnf.csiro.au)
mtrr: detected mtrr type: Intel
PCI: PCI BIOS revision 2.10 entry at 0xfc06e, last bus=8
PCI: Using configuration type 1
PCI: Probing PCI hardware
Unknown bridge resource 2: assuming transparent
Unknown bridge resource 2: assuming transparent
PCI: Using IRQ router PIIX [8086/244c] at 00:1f.0
  got res[f2000000:f2000fff] for resource 0 of Texas Instruments PCI4451 PC card Cardbus Controller
  got res[f2001000:f2001fff] for resource 0 of Texas Instruments PCI4451 PC card Cardbus Controller (#2)
isapnp: Scanning for Pnp cards...
isapnp: No Plug & Play device found
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
apm: BIOS version 1.2 Flags 0x03 (Driver version 1.14)
Starting kswapd v1.8
pty: 256 Unix98 ptys configured
block: queued sectors max/low 169770kB/56590kB, 512 slots per queue
Uniform Multi-Platform E-IDE driver Revision: 6.31
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
PCI_IDE: unknown IDE controller on PCI bus 00 device f9, VID=8086, DID=244a
PCI_IDE: chipset revision 2
PCI_IDE: not 100% native mode: will probe irqs later
    ide0: BM-DMA at 0xbfa0-0xbfa7, BIOS settings: hda:DMA, hdb:DMA
    ide1: BM-DMA at 0xbfa8-0xbfaf, BIOS settings: hdc:pio, hdd:pio
hda: IBM-DJSA-232, ATA DISK drive
hdb: TOSHIBA DVD-ROM SD-C2402, ATAPI CD/DVD-ROM drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
hda: 62506080 sectors (32003 MB) w/1874KiB Cache, CHS=3890/255/63
hdb: ATAPI 24X DVD-ROM drive, 128kB Cache, UDMA(33)
Uniform CD-ROM driver Revision: 3.12
Partition check:
 hda: hda1 hda2 hda3 hda4 < hda5 hda6 >
Floppy drive(s): fd0 is 1.44M
FDC 0 is a post-1991 82077
Serial driver version 5.02 (2000-08-09) with MANY_PORTS SHARE_IRQ SERIAL_PCI ISAPNP enabled
ttyS00 at 0x03f8 (irq = 4) is a 16550A
eepro100.c:v1.09j-t 9/29/99 Donald Becker http://cesdis.gsfc.nasa.gov/linux/drivers/eepro100.html
eepro100.c: $Revision: 1.36 $ 2000/11/17 Modified by Andrey V. Savochkin <saw@saw.sw.com.sg> and others
eth0: OEM i82557/i82558 10/100 Ethernet, 00:20:E0:64:49:64, IRQ 11.
  Receiver lock-up bug exists -- enabling work-around.
  Board assembly 727095-002, Physical connectors present: RJ45
  Primary interface chip i82555 PHY #1.
  General self-test: passed.
  Serial sub-system self-test: passed.
  Internal registers self-test: passed.
  ROM checksum self-test: passed (0x04f4518b).
  Receiver lock-up workaround activated.
Linux PCMCIA Card Services 3.1.22
  options:  [pci] [cardbus] [pm]
PCI: Found IRQ 11 for device 02:0f.0
PCI: The same IRQ used for device 00:1f.2
PCI: The same IRQ used for device 02:0f.1
PCI: The same IRQ used for device 02:0f.2
PCI: Found IRQ 11 for device 02:0f.1
PCI: The same IRQ used for device 00:1f.2
PCI: The same IRQ used for device 02:0f.0
PCI: The same IRQ used for device 02:0f.2
Intel PCIC probe: not found.
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
IP: routing cache hash table of 2048 buckets, 16Kbytes
TCP: Hash tables configured (established 16384 bind 16384)
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
Yenta IRQ list 0698, PCI irq11
Socket status: 30000006
Yenta IRQ list 0698, PCI irq11
Socket status: 30000006
VFS: Mounted root (ext2 filesystem) readonly.
Freeing unused kernel memory: 188k freed
Adding Swap: 281096k swap-space (priority -1)
Linux agpgart interface v0.99 (c) Jeff Hartmann
agpgart: Maximum main memory to use for agp memory: 203M
agpgart: agpgart: Detected an Intel i815, but could not find the secondary device. Assuming a non-integrated video card.
agpgart: Detected Intel i815 chipset
agpgart: AGP aperture is 64M @ 0xe4000000
eth0: 0 multicast blocks dropped.