Hi Doug,
I've got linux 2.2.16pre7 patched with aic7xx 5.1.29 and 5.1.30.
I still get the data overrun error for my Western digital 9gig drive
on my 333mhz Dell optiplex GX1 computer. Any luck fixing this?
Here is my dmesg:
************************
Linux version 2.2.16pre7 (root@DosLinux) (gcc version egcs-2.91.66 19990314 (egcs-1.1.2 release)) #1 SMP Wed May 31 20:29:13 /etc/localtime 2000
mapped APIC to ffffe000 (0031d000)
Detected 331713 kHz processor.
[snipped some]
RAM disk driver initialized: 16 RAM disks of 4096K size
PIIX4: IDE controller on PCI bus 00 dev 39
PIIX4: not 100% native mode: will probe irqs later
ide1: BM-DMA at 0xffa8-0xffaf, BIOS settings: hdc:DMA, hdd:DMA
hdc: QUANTUM FIREBALL_TM1280A, ATA DISK drive
hdd: TOSHIBA CD-ROM XM-6202B, ATAPI CDROM drive
ide1 at 0x170-0x177,0x376 on irq 15
hdc: QUANTUM FIREBALL_TM1280A, 1222MB w/76kB Cache, CHS=2484/16/63, DMA
hdd: ATAPI 32X CD-ROM drive, 256kB Cache
Uniform CD-ROM driver Revision: 3.08
Floppy drive(s): fd0 is 1.44M
FDC 0 is a National Semiconductor PC87306
md driver 0.36.6 MAX_MD_DEV=4, MAX_REAL=8
(scsi0) <Adaptec AIC-7895 Ultra SCSI host adapter> found at PCI 0/14/0
(scsi0) Wide Channel A, SCSI ID=7, 32/255 SCBs
(scsi0) Cables present (Int-50 NO, Int-68 YES, Ext-68 NO)
(scsi0) Downloading sequencer code... 383 instructions downloaded
(scsi1) <Adaptec AIC-7895 Ultra SCSI host adapter> found at PCI 0/14/1
(scsi1) Narrow Channel B, SCSI ID=7, 32/255 SCBs
(scsi1) Cables present (Int-50 NO, Ext-50 NO)
(scsi1) Downloading sequencer code... 383 instructions downloaded
scsi0 : Adaptec AHA274x/284x/294x (EISA/VLB/PCI-Fast SCSI) 5.1.30/3.2.4
<Adaptec AIC-7895 Ultra SCSI host adapter>
scsi1 : Adaptec AHA274x/284x/294x (EISA/VLB/PCI-Fast SCSI) 5.1.30/3.2.4
<Adaptec AIC-7895 Ultra SCSI host adapter>
scsi : 2 hosts.
(scsi0:0:0:0) Synchronous at 40.0 Mbyte/sec, offset 8.
(scsi0:0:0:0) Data overrun detected in Data-In phase, tag 1;
Have seen Data Phase. Length=255, NumSGs=1.
sg[0] - Addr 0x7f9c260 : Length 255
Vendor: WDIGTL Model: WDE9100-1807A4 Rev: 1.30
Type: Direct-Access ANSI SCSI revision: 02
Detected scsi disk sda at scsi0, channel 0, id 0, lun 0
scsi : detected 1 SCSI generic 1 SCSI disk total.
SCSI device sda: hdwr sector= 512 bytes. Sectors= 17783204 [8683 MB] [8.7 GB]
Partition check:
sda: sda1 sda2 < sda5 sda6 sda7 >
hdc: [PTBL] [621/64/63] hdc1
UMSDOS 0.85g (compatibility level 0.4, fast msdos)
[snipped some more]
Thanks.
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.rutgers.edu
Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Wed Jun 07 2000 - 21:00:12 EST