I have an UP2000 alpha linux, RH6.2, linus kernel 2.2.15, with a Mylex
DAC960SX scsi-to-scsi controler. There are three logical disks configured,
however, only the first is auto-detected by the kernel:
--- Detected scsi disk sdb at scsi1, channel 0, id 1, lun 0 Vendor: MYLEX Model: DAC960SX 43415B0 Rev: 0312 Type: Direct-Access ANSI SCSI revision: 02 ---lun 1 and 2 have to be added by hand with to be accesible
echo "scsi add-single-device 1 0 5 1" > /proc/scsi/scsi echo "scsi add-single-device 1 0 5 2" > /proc/scsi/scsi
cat /proc/scsi/scsi: ----- Host: scsi1 Channel: 00 Id: 05 Lun: 00 Vendor: MYLEX Model: DAC960SX 43415B0 Rev: 0312 Type: Direct-Access ANSI SCSI revision: 02 Host: scsi1 Channel: 00 Id: 05 Lun: 01 Vendor: MYLEX Model: DAC960SX 69464B0 Rev: 0312 Type: Direct-Access ANSI SCSI revision: 02 Host: scsi1 Channel: 00 Id: 05 Lun: 02 Vendor: MYLEX Model: DAC960SX 95404B0 Rev: 0312 Type: Direct-Access ANSI SCSI revision: 02 ------
Is this a bug or is there another solution? If I have lun1,2 in /etc/fstab boot fails on fsck on those two devices.
Andrej
- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.rutgers.edu Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Mon May 15 2000 - 21:00:25 EST