On Tue, 22 Feb 2000, Alan Cox wrote:
> > I'm soon giving up trying to get some packets go through a shaper device.
> > Alan or someone else who knows, is it really in a working state in 2.2.14?
>
> If you can see this then it worked.
>
> > $ shapecfg attach shaper0 eth1
> > $ shapecfg speed shaper0 64000
> > $ ifconfig shaper0 192.168.0.1 netmask 255.255.255.0 broadcast 192.168.0.255
> ^up ?
Um, up? Not really sure what you are trying to say there, but it is up
acording to ifconfig (sometimes you are a bit too few worded :)
$ ifconfig shaper0
shaper0 Link encap:Ethernet HWaddr 00:00:00:00:00:00
inet addr:192.168.0.1 Mask:255.255.255.0
UP RUNNING MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:34 errors:0 dropped:0 overruns:0 carrier:0
Collisions:0
Best Regards
Daniel Ryde, System Administrator
__________________________________________________________________________
Tripnet AB Visit Address: Telephone: +46 31 7252500
Box 5071 Avagen 42 Facsimile: +46 31 7252501
S-402 22 GOTEBORG GOTEBORG Email: ryde@tripnet.se
Sweden Sweden
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.rutgers.edu
Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Wed Feb 23 2000 - 21:00:30 EST