On 21 Feb, buddy@dookie.net wrote:
> I have a DLink DFE-500TX PCI network card which uses the de4x5
> driver. It works w/ both the de4x5 driver and the tulip driver.
> However, as of 2.3.47, the de4x5 driver no longer works.
Experiencing the same problem the other way round.
Bus 0, device 11, function 0:
Ethernet controller: Digital Equipment Corporation DECchip 21142/43 (rev 65).
IRQ 12.
Master Capable. Latency=96. Min Gnt=20.Max Lat=40.
I/O at 0xe000 [0xe07f].
Non-prefetchable 32 bit memory at 0xed001000 [0xed0013ff].
This one works fine with de4x5 but not with tulip although it's
supported and detected fine I don't get any packets through.
Did cost me quite a lot of time to discover this. My first thoughts
were anything but a driver getting no bytes through :/
--Servus, Daniel
- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.rutgers.edu Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Wed Feb 23 2000 - 21:00:28 EST