Daniel Egger writes:
> On 16 Feb, Richard Gooch wrote:
>
> > Linux PCMCIA Card Services 3.1.11
> > options: [pci] [cardbus] [apm]
> > Adding cardbus controller 0: PCI device 104c:ac15
> > PCI: Enabling device 00:04.0 (0000 -> 0002)
> > Yenta IRQ list 0000, PCI irq0
> > Socket status: 30000059
> > Adding cardbus controller 1: PCI device 104c:ac15
> > PCI: Enabling device 00:04.1 (0000 -> 0002)
> > Yenta IRQ list 0000, PCI irq0
> > [...]
> > cs: IO port probe 0x038c-0x03ff: excluding 0x3c4-0x3e3 0x3ec-0x403
> > cs: IO port probe 0x0230-0x0387: excluding 0x378-0x37f
> > cs: IO port probe 0x0100-0x021f: clean.
> > cs: memory probe 0xa0000000-0xa0ffffff: clean.
> > xirc2ps_cs.c 1.31 1998/12/09 19:32:55 (dd9jn+kvh)
> > xirc2ps_cs: RequestIRQ: Resource in use
>
> > Bugger.
>
> I normally get the same output but sometimes it just works...
> strange...
Well, at the moment I'm using my other network card with 2.3.46-pre2
and it's working:
Linux PCMCIA Card Services 3.1.11
options: [pci] [cardbus] [apm]
Adding cardbus controller 0: PCI device 104c:ac15
PCI: Enabling device 00:04.0 (0000 -> 0002)
Yenta IRQ list 0e98, PCI irq0
Socket status: 30000010
Adding cardbus controller 1: PCI device 104c:ac15
PCI: Enabling device 00:04.1 (0000 -> 0002)
Yenta IRQ list 0e88, PCI irq0
Socket status: 30000006
[...]
cs: IO port probe 0x038c-0x03ff: excluding 0x3c4-0x3e3 0x3ec-0x403
cs: IO port probe 0x0230-0x0387: excluding 0x378-0x37f
cs: IO port probe 0x0100-0x021f: clean.
cs: memory probe 0xa0000000-0xa0ffffff: clean.
eth0: NE2000 Compatible: io 0x300, irq 3, hw_addr 00:40:33:9A:22:26
The difference seems to be that this card is 16 bit, whereas the other
card is (it had better be!) 32 bit.
Regards,
Richard....
Permanent: rgooch@atnf.csiro.au
Current: rgooch@ras.ucalgary.ca
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.rutgers.edu
Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Wed Feb 23 2000 - 21:00:16 EST