Ok,
I just got a "NIC100" linksys 10/100 card. I compiled the driver
into the kernel for the DEC Tulip drivers. After installing the kernel
just like normal I reboot. The device, eth0, is visable, up and apparently
see'ing packets. I can't use the interface though.
I can't paste it since it's not on the network but I can read it.
TX packets: 1554 errors:0 dropped:0 overruns:0 carrier:0
RX packets: 0 errors:4 dropped:3794 overruns:0 carrier:0
collisons:0 txqueuelen:100
Interrupt:9 Base address:0xe800
Everything else looks just like what was in the last card and this
machines. The card works fine in Windows.
The machine:
AMD-K6-2-500 (not overclocked)
128Meg mem
IDE disks
kernel 2.2.15-pre-4
HELP?
Robert
:wq!
---------------------------------------------------------------------------
Robert L. Harris | Low quality in a product happens.
Senior System Engineer | That doesn't mean it's right and
at RnD Consulting. | definitely doesn't mean it should
\_ be accepted. Require quality.
http://www.rnd-consulting.com/~nomad
DISCLAIMER:
These are MY OPINIONS ALONE. I speak for no-one else.
FYI:
perl -e 'print $i=pack(c5,(41*2),sqrt(7056),(unpack(c,H)-2),oct(115),10);'
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.rutgers.edu
Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Mon Feb 07 2000 - 21:00:12 EST