[PATCH 1/2] net: dsa: qca8k: support internal-PHY-to-PHY CPU link

[Ziyang Huang]

internal-PHY-to-PHY CPU link is a common/demo design in IPQ50xx platform,
since it only has a SGMII/SGMII+ link and a MDI link.

For DSA, CPU tag is the only requirement. Fortunately, qca8337 can enable
it on any port. So it's ok to trust a internal-PHY-to-PHY link as a CPU
link.

Signed-off-by: Ziyang Huang <hzyitc@xxxxxxxxxxx>
---
 drivers/net/dsa/qca/qca8k-8xxx.c | 12 +++++++-----
 1 file changed, 7 insertions(+), 5 deletions(-)

diff --git a/drivers/net/dsa/qca/qca8k-8xxx.c b/drivers/net/dsa/qca/qca8k-8xxx.c
index e8cb4da15dbe..be9a8170c048 100644
--- a/drivers/net/dsa/qca/qca8k-8xxx.c
+++ b/drivers/net/dsa/qca/qca8k-8xxx.c
@@ -1014,7 +1014,7 @@ qca8k_setup_mdio_bus(struct qca8k_priv *priv)
 			return ret;
 		}
 
-		if (!dsa_is_user_port(priv->ds, reg))
+		if (reg == 0 || reg == 6)
 			continue;
 
 		of_get_phy_mode(port, &mode);
@@ -1089,17 +1089,19 @@ qca8k_setup_mac_pwr_sel(struct qca8k_priv *priv)
 
 static int qca8k_find_cpu_port(struct dsa_switch *ds)
 {
-	struct qca8k_priv *priv = ds->priv;
+	int i;
 
-	/* Find the connected cpu port. Valid port are 0 or 6 */
 	if (dsa_is_cpu_port(ds, 0))
 		return 0;
 
-	dev_dbg(priv->dev, "port 0 is not the CPU port. Checking port 6");
-
 	if (dsa_is_cpu_port(ds, 6))
 		return 6;
 
+	/* PHY-to-PHY link */
+	for (i = 1; i <= 5; i++)
+		if (dsa_is_cpu_port(ds, i))
+			return i;
+
 	return -EINVAL;
 }
 
-- 
2.40.1