I have a simple routing question. I have a firewall box with two
interfaces in it. It is only routing a single class C. Here is how it's
setup:
[server1]----[server2]------[eth0][FW][eth1]------[server3]------[server4]
Server 1 has an address of 192.168.0.50
Server 2 has an address of 192.168.0.51
Firewall eth0 has an address of 192.168.0.10
Firewall eth1 has an address of 192.168.0.11
Server 3 has an address of 192.168.0.90
Server 4 has an address of 192.168.0.91
Here is the problem, I can get on the firewall/proxy and ping the eth0
interface and both server 1 and 2 BUT I can not ping server 3 or 4 OR the
eth1 interface.
What would be the easiest way to route those IP addresses over both of the
interfaces in the firewall? This is on linux slakware 3.4. I had it setup
to where it would route two different subnets, 192.168.2.0/24 on one side
and 192.168.0.0/24 on the other and it worked fine. What am I doing wrong
for a simple single class C?
Thanks
\|///////////////////////////////// \\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\|/
- Dan O'Neal -( )- dan@emdnet.com -
/|\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\ ///////////////////////////////////|\
-
To unsubscribe from this list: send the line "unsubscribe linux-net" in
the body of a message to majordomo@vger.rutgers.edu