my system has two 3Com 3c905B Cyclone 100baseTx cards....
eth0: 3Com 3c905B Cyclone 100baseTx at 0x6000, 00:10:4b:c5:4b:35, IRQ 9
8K byte-wide RAM 5:3 Rx:Tx split, autoselect/NWay Autonegotiation interface.
Enabling bus-master transmits and whole-frame receives.
eth1: 3Com 3c905B Cyclone 100baseTx at 0x6100, 00:10:4b:c5:4b:d5, IRQ 10
8K byte-wide RAM 5:3 Rx:Tx split, autoselect/NWay Autonegotiation interface.
Enabling bus-master transmits and whole-frame receives.
3c59x.c:v0.99E 5/12/98 Donald Becker http://cesdis.gsfc.nasa.gov/linux/drivers/vortex.html
when I'm getting these errors the interface "eth1" does not allow the
network Application-level to function.... example, I can telnet from the
system to another, outbound on "eth1", run tcpdump on the interface and
see the packets transfer, but the Application interface never surfaces.
Doing an ifconfig down;ifconfig up, and then resetting the routes, temporarily
fixes the problem, but only for a few minutes.
I originally had the problem on 2.0.33, but I upgraded to 2.0.34 and
the problem remains. (v0.99 on the 3c59x.c driver on 2.0.34).
-- Frank Koenen- To unsubscribe from this list: send the line "unsubscribe linux-net" in the body of a message to majordomo@vger.rutgers.edu