Before installing shaper everything works all right, but after installing
shaper device eth1 (now shaper0) does not work, and some errors are
visible. Error message is:
eth1: Transmit timed out: status 2040 command 0000.
eth1: Tx timeout fill index 14 scavenge index 0.
Tx queue 000ca000 000ca000 000ca000 000ca000 000ca000 000ca000 000ca000 000
ca000 000ca000 000ca000 000ca000 000ca000 000ca000 400ca000 00000000 00000000.
Rx ring 00000001 00000001 00000001 00000001 00000001 00000001 00000001 0000
0001 00000001 00000001 00000001 00000001 00000001 00000001 00000001 00000001.
eth1: Trying to restart the transmitter...
Network cards are EtherExpress Pro 100 (eepro100), linux is 2.0.33
(shaper patched).
Shaper is invoked by lines:
insmod shaper
shapecfg attach shaper0 eth1
shapecfg speed shaper0 64000
ifconfig shaper0 193.84.192.19 netmask 255.255.255.0 broadcast 193.84.192.255 up
route add -host 193.84.192.1 shaper0
route add default gw 193.84.192.1 shaper0
eth0 is started before; some other routes are installed before too.
Interesting is, thar errors occures after try to use corresponding line,
and than does not stop even if shaper is down (ifconfig shaper0 down)...
+-----------------------------------+
| |
| Radim HABALA |
| |
| e-mail: hab21um@fpf.slu.cz |
| |
| Englisova 13, OPAVA, 746 01 |
| Czech Republic (Europe) |
| |
| tel : (0653) 21 46 34 |
| |
+-----------------------------------+
-
To unsubscribe from this list: send the line "unsubscribe linux-net" in
the body of a message to majordomo@vger.rutgers.edu