Re: cannot fill 100Mbps pipe (over 20ms rtt via netem)?
Date: Thu May 01 2008 - 01:19:52 EST
On Wed, Apr 30, 2008 at 5:43 PM, slashdev <slashdev@xxxxxxxxx> wrote:
> On Wed, Apr 30, 2008 at 5:27 PM, John Heffner <johnwheffner@xxxxxxxxx> wrote:
> > Both traces show lots of packet loss -- enough to cause an equilibrium
> > cwnd of less than 100 KB. With a short RTT, this window is adequate
> > to fill a 100 Mbps pipe, but with even a 20 ms RTT, it's hurting you.
> > I'm not sure where the packet loss is coming from. Possibly an
> > overloaded switch or bad cable?
> thanks for the insight. will take a look at my setup and see why that
> should happen. will report back once i am done fixing things at my
just a quick note. i turned off TSO on both ends and w/o any cable
swap (or switch port change), the thruput jumped from 30Mbps to
60Mbps for the 20ms rtt case. not sure what would cause that.
further, the 100 Mbps link that i've been referring to, is actually
composed of GigE cards at the endpoints over a 100Mbps vlan.
just wanted to point out these two facts while i get busy fixing
up any potential cabling or switch problems. will also report back
how does cross-over cable fair in this setup...
To unsubscribe from this list: send the line "unsubscribe linux-net" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html