This is a stupid question...but I have two network cards in my
machine..They are both based on the tulip.c driver which I have just
downloaded and compiled as a module....I looked in the /proc/pci and
the kernel recognizes the cards at boot up...now how do I load a
module for each of the cards so that one has the alias eth0 and the
other eth1
what is the command line for loading this module?
I'm feeling stupid right now. maybe its the fact that I've been up 72
hours programming this linux router software..DOH!!!
Thanks,
Brent
-
To unsubscribe from this list: send the line "unsubscribe linux-net" in
the body of a message to majordomo@vger.rutgers.edu
This archive was generated by hypermail 2b29 : Tue Feb 29 2000 - 21:00:26 EST