It loops around
PCI: Discovered primary peer bus ....
when it hits 100, 01 and 02,
It panics (want to dereference a null pointer].
(when I turn on debugging, it scrolls by too fast to see).
I also played around with no bios/only direct access..
/proc/pci (with 2.0.35) says:
: leisner@compudyne;cat /proc/pci
PCI devices found:
Bus 0, device 8, function 0:
Non-VGA device: NCR 53c810 (rev 1).
Medium devsel. IRQ 10. Master Capable. Latency=96.
I/O at 0xd000.
Non-prefetchable 32 bit memory at 0x3800000.
Bus 0, device 5, function 0:
Host bridge: Acer Incorporated M1435 (rev 0).
Slow devsel. Master Capable. No bursts.
2.1. used to work until recently (I think the last one I used
on this machine was 2.1.10?)
It works without PCI (which is fine since I rarely use the
PCI bus in that machine).
It probably would be desirable for the code to detect loops
and break out, disabling PCI...instead of infinite looping and then
Don't confuse education with schooling.
Milton Friedman to Yogi Berra
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to email@example.com
Please read the FAQ at http://www.altern.org/andrebalsa/doc/lkml-faq.html