Re: [PATCH v3] arm: dts: bcm2711: Describe Ethernet LEDs

From: Stefan Wahren
Date: Tue Apr 23 2024 - 15:53:58 EST

Next message: gregkh@xxxxxxxxxxxxxxxxxxx: "Re: [PATCH] mei: bus: constify the struct mei_cl_bus_type usage"
Previous message: Cary Garrett: "After suspend/resume cycle ASPEED VGA monitor suffers with "No Signal" state."
In reply to: Florian Fainelli: "[PATCH v3] arm: dts: bcm2711: Describe Ethernet LEDs"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

Am 23.04.24 um 21:14 schrieb Florian Fainelli:

Describe the Ethernet LEDs for the Raspberry Pi 4 model B board as well
as the Raspberry Pi 4 CM board. The Raspberry Pi 400 board does not
include RJ45 connector LEDs so the 'leds' node is deleted accordingly.

The Ethernet PHY LEDs are numbered in the PHY package/pin list from LED1
through LED4, however their address within the LED registers function
selector is 0-indexed.

Signed-off-by: Florian Fainelli <florian.fainelli@xxxxxxxxxxxx>

Reviewed-by: Stefan Wahren <wahrenst@xxxxxxx>

Next message: gregkh@xxxxxxxxxxxxxxxxxxx: "Re: [PATCH] mei: bus: constify the struct mei_cl_bus_type usage"
Previous message: Cary Garrett: "After suspend/resume cycle ASPEED VGA monitor suffers with "No Signal" state."
In reply to: Florian Fainelli: "[PATCH v3] arm: dts: bcm2711: Describe Ethernet LEDs"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]