Re: [RFC PATCH 2/2] net: phy: mxl-gpy: add new device tree property to disable SGMII autoneg

From: Russell King (Oracle)
Date: Tue Apr 16 2024 - 11:49:06 EST


On Tue, Apr 16, 2024 at 05:43:16PM +0200, Stefan Eichenberger wrote:
> Hi Andrew,
>
> Thanks a lot for the feedback.
>
> On Tue, Apr 16, 2024 at 03:46:19PM +0200, Andrew Lunn wrote:
> > On Tue, Apr 16, 2024 at 02:10:32PM +0200, Stefan Eichenberger wrote:
> > > Add a new device tree property to disable SGMII autonegotiation and
> > > instead use the option to match the SGMII speed to what was negotiated
> > > on the twisted pair interface (tpi).
> >
> > Could you explain this is more detail.
> >
> > SGMII always runs its clocks at 1000Mbps. The MAC needs to duplicate
> > the symbols 100 times when running at 10Mbs, and 10 times when running
> > at 100Mbps.
>
> Currently, the mxl-gpy driver uses SGMII autonegotiation for 10 Mbps,
> 100 Mbps, and 1000 Mbps. For our Ethernet controller, which is on an
> Octeon TX2 SoC, this means that we have to enable "in-band-status" on
> the controller. This will work for all three speed settings. However, if
> we have a link partner that can do 2.5 Gbps, the mxl-gpy driver will
> disable SGMII autonegotiation in gpy_update_interface. This is not
> supported by this Ethernet controller because in-band-status is still
> enabled. Therefore, we will not be able to transfer data at 2.5 Gbps,
> the SGMII link will not go into a working state.

I have been working on a phylink/phylib patch set to address this. As
I've been busy with health-based appointments during last week and this
week, I haven't been able to spend enough time to get that to a point
that I'm happy to publish it yet.

--
RMK's Patch system: https://www.armlinux.org.uk/developer/patches/
FTTP is here! 80Mbps down 10Mbps up. Decent connectivity at last!