Re: [RFC 6/8] arm: dts: qcom: Add pmic glink support for sm8450-qrd

[Krishna Kurapati PSSNV]

On 10/27/2023 1:11 AM, Konrad Dybcio wrote:
> On 10/17/23 15:18, Krishna Kurapati wrote:
> > Add Pmic Glink support for sm8450-qrd to facilitate passing
> > of roe switch notifications generated by ADSP to dwc3 core
> > via ucsi and pmic glink's.
> >
> > Signed-off-by: Krishna Kurapati <quic_kriskura@xxxxxxxxxxx>
> > ---
> No phy+redriver+dp configuration?
Hi Konrad,

 Did you mean adding the following node:

        typec-mux@42 {
                compatible = "fcs,fsa4480";
                reg = <0x42>;

                interrupts-extended = <&tlmm 2 IRQ_TYPE_LEVEL_LOW>;

                vcc-supply = <&vreg_bob>;
                mode-switch;
                orientation-switch;

                port {
                        fsa4480_sbu_mux: endpoint {
                                remote-endpoint = <&pmic_glink_sbu>;
                        };
                };
        };


and then adding port-2 for pmic_glink ?

Usually for role-switch the port-0/1 defined in this patch are 
sufficient. Also if I added it, I don't have a way to currently test it. 
So skipped this node. I will try and see if I can test it and add it if 
possible.

Regards,
Krishna,