Re: [PATCH v2 2/2] PCI: hotplug: Add extension driver for Ampere Altra hotplug LED control

[D Scott Phillips]

Bjorn Helgaas <helgaas@xxxxxxxxxx> writes:

> On Fri, Sep 29, 2023 at 05:20:36PM -0700, D Scott Phillips wrote:
>> On Ampere Altra, PCIe hotplug is handled through ACPI. A side interface is
>> also present to request system firmware control of attention LEDs. Add an
>> ACPI PCI Hotplug companion driver to support attention LED control.
>> ...
>
>> +	arm_smccc_smc(REQUEST, LED_CMD, led_status(status), LED_ATTENTION,
>> +		      pci_domain_nr(bus) | (PCI_SLOT(root_port->devfn) << 4), 0, 0,
>
> pci_domain_nr() returns "int" (normally 32 bits), but since this is an
> ACPI system, the domain comes from _SEG, which is defined to be 16
> bits (ACPI r6.5, sec 6.5.6).
>
> So it looks like ORing in the "slot << 4" clobbers the upper 12 bits
> of _SEG.
>
> Is this code doing the right thing?

Hi Bjorn,

on these Altra platforms _SEG is limited within 0-11. I can add an `&
0xf` to pci_domain_nr() to make it clear that the segment number is
encoded down into 4 bits in the smc request.