Linux version 2.4.18-4GB (root@Pentium.suse.de) (gcc version 2.95.3 20010315 (SuSE)) #1 Wed Mar 27 13:57:05 UTC 2002
BIOS-provided physical RAM map:
 BIOS-e820: 0000000000000000 - 000000000009f000 (usable)
 BIOS-e820: 000000000009f000 - 00000000000a0000 (reserved)
 BIOS-e820: 00000000000dc000 - 0000000000100000 (reserved)
 BIOS-e820: 0000000000100000 - 000000001f760000 (usable)
 BIOS-e820: 000000001f760000 - 000000001f77a000 (ACPI data)
 BIOS-e820: 000000001f77a000 - 000000001f77c000 (ACPI NVS)
 BIOS-e820: 000000001f77c000 - 0000000020000000 (reserved)
 BIOS-e820: 00000000ff800000 - 0000000100000000 (reserved)
Scanning bios EBDA for MXT signature
On node 0 totalpages: 128864
zone(0): 4096 pages.
zone(1): 124768 pages.
zone(2): 0 pages.
Building zonelist for node : 0
Kernel command line: auto BOOT_IMAGE=linux ro root=303
Initializing CPU#0
Detected 1196.041 MHz processor.
Console: colour VGA+ 80x25
Calibrating delay loop... 2385.51 BogoMIPS
Memory: 504200k/515456k available (1389k kernel code, 10868k reserved, 406k data, 120k init, 0k highmem)
Dentry-cache hash table entries: 65536 (order: 7, 524288 bytes)
Inode-cache hash table entries: 32768 (order: 6, 262144 bytes)
Mount-cache hash table entries: 512 (order: 0, 4096 bytes)
Buffer-cache hash table entries: 32768 (order: 5, 131072 bytes)
Page-cache hash table entries: 131072 (order: 7, 524288 bytes)
CPU: Before vendor init, caps: 0383f9ff 00000000 00000000, vendor = 0
CPU: L1 I cache: 16K, L1 D cache: 16K
CPU: L2 cache: 512K
CPU: After vendor init, caps: 0383f9ff 00000000 00000000 00000000
Intel machine check architecture supported.
Intel machine check reporting enabled on CPU#0.
CPU:     After generic, caps: 0383f9ff 00000000 00000000 00000000
CPU:             Common caps: 0383f9ff 00000000 00000000 00000000
CPU: Intel Mobile Intel(R) Pentium(R) III CPU - M  1200MHz stepping 04
Enabling fast FPU save and restore... done.
Enabling unmasked SIMD FPU exception support... done.
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
mtrr: v1.40 (20010327) Richard Gooch (rgooch@atnf.csiro.au)
mtrr: detected mtrr type: Intel
PCI: PCI BIOS revision 2.10 entry at 0xfd90e, last bus=7
PCI: Using configuration type 1
PCI: Probing PCI hardware
PCI: Discovered primary peer bus 08 [IRQ]
PCI: Using IRQ router PIIX [8086/248c] at 00:1f.0
PCI: Found IRQ 11 for device 00:1f.1
PCI: Sharing IRQ 11 with 00:1d.2
PCI: Sharing IRQ 11 with 01:00.2
PCI: Sharing IRQ 11 with 01:02.0
PCI: Cannot allocate resource region 0 of device 01:00.0
PCI: Cannot allocate resource region 0 of device 01:00.1
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Initializing RT netlink socket
IBM machine detected. Enabling interrupts during APM calls.
apm: BIOS version 1.2 Flags 0x03 (Driver version 1.16)
mxt_scan_bios: enter
Starting kswapd
kinoded started
VFS: Diskquotas version dquot_6.5.0 initialized
ACPI: APM is already active, exiting
pty: 256 Unix98 ptys configured
Serial driver version 5.05c (2001-07-08) with HUB-6 MANY_PORTS MULTIPORT SHARE_IRQ SERIAL_PCI SERIAL_ACPI enabled
PCI: Found IRQ 5 for device 00:1f.6
PCI: Sharing IRQ 5 with 00:1f.3
PCI: Sharing IRQ 5 with 00:1f.5
PCI: Sharing IRQ 5 with 01:00.1
Real Time Clock Driver v1.10e
block: 128 slots per queue, batch=32
RAMDISK driver initialized: 16 RAM disks of 64000K size 1024 blocksize
Uniform Multi-Platform E-IDE driver Revision: 6.31
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
PIIX4: IDE controller on PCI bus 00 dev f9
PCI: Enabling device 00:1f.1 (0005 -> 0007)
PCI: Found IRQ 11 for device 00:1f.1
PCI: Sharing IRQ 11 with 00:1d.2
PCI: Sharing IRQ 11 with 01:00.2
PCI: Sharing IRQ 11 with 01:02.0
PIIX4: chipset revision 2
PIIX4: not 100% native mode: will probe irqs later
    ide0: BM-DMA at 0x1860-0x1867, BIOS settings: hda:DMA, hdb:pio
    ide1: BM-DMA at 0x1868-0x186f, BIOS settings: hdc:pio, hdd:pio
hda: HITACHI_DK23EA-40B, ATA DISK drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
blk: queue c031ece4, I/O limit 4095Mb (mask 0xffffffff)
hda: safely enabled flush
hda: 78140160 sectors (40008 MB) w/2048KiB Cache, CHS=5168/240/63, UDMA(100)
ide-floppy driver 0.99
Partition check:
 hda: hda1 hda2 hda3 hda4
Floppy drive(s): fd0 is 1.44M
floppy0: no floppy controllers found
loop: loaded (max 16 devices)
Cronyx Ltd, Synchronous PPP and CISCO HDLC (c) 1994
Linux port (c) 1998 Building Number Three Ltd & Jan "Yenya" Kasprzak.
ide-floppy driver 0.99
SCSI subsystem driver Revision: 1.00
request_module[scsi_hostadapter]: Root fs not mounted
request_module[scsi_hostadapter]: Root fs not mounted
md: md driver 0.90.0 MAX_MD_DEVS=256, MD_SB_DISKS=27
md: Autodetecting RAID arrays.
md: autorun ...
md: ... autorun DONE.
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
IP: routing cache hash table of 4096 buckets, 32Kbytes
TCP: Hash tables configured (established 32768 bind 32768)
Linux IP multicast router 0.06 plus PIM-SM
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
RAMDISK: Compressed image found at block 0
Uncompressing............done.
Freeing initrd memory: 493k freed
VFS: Mounted root (ext2 filesystem).
VFS: Mounted root (ext2 filesystem) readonly.
change_root: old root has d_count=2
Trying to unmount old root ... okay
Freeing unused kernel memory: 120k freed
md: Autodetecting RAID arrays.
md: autorun ...
md: ... autorun DONE.
Adding Swap: 1050832k swap-space (priority 42)
Intel(R) PRO/100 Fast Ethernet Adapter - Loadable driver, ver 1.8.37
Copyright (c) 2002 Intel Corporation
PCI: Found IRQ 11 for device 01:08.0

eth0: Intel(R) PRO/100 VE Network Connection
  Mem:0xd0200000  IRQ:11  Speed:0 Mbps  Dx:N/A
  Failed to detect cable link.
  Speed and duplex will be determined at time of connection.
  Hardware receive checksums enabled
usb.c: registered new driver usbdevfs
usb.c: registered new driver hub
usb-uhci.c: $Revision: 1.275 $ time 14:22:01 Mar 27 2002
usb-uhci.c: High bandwidth mode enabled
PCI: Found IRQ 11 for device 00:1d.0
PCI: Sharing IRQ 11 with 00:02.0
PCI: Sharing IRQ 11 with 01:00.0
PCI: Setting latency timer of device 00:1d.0 to 64
usb-uhci.c: USB UHCI at I/O 0x1800, IRQ 11
usb-uhci.c: Detected 2 ports
usb.c: new USB bus registered, assigned bus number 1
hub.c: USB hub found
hub.c: 2 ports detected
PCI: Found IRQ 11 for device 00:1d.1
PCI: Setting latency timer of device 00:1d.1 to 64
usb-uhci.c: USB UHCI at I/O 0x1820, IRQ 11
usb-uhci.c: Detected 2 ports
usb.c: new USB bus registered, assigned bus number 2
hub.c: USB hub found
hub.c: 2 ports detected
PCI: Found IRQ 11 for device 00:1d.2
PCI: Sharing IRQ 11 with 00:1f.1
PCI: Sharing IRQ 11 with 01:00.2
PCI: Sharing IRQ 11 with 01:02.0
PCI: Setting latency timer of device 00:1d.2 to 64
usb-uhci.c: USB UHCI at I/O 0x1840, IRQ 11
usb-uhci.c: Detected 2 ports
usb.c: new USB bus registered, assigned bus number 3
hub.c: USB hub found
hub.c: 2 ports detected
usb-uhci.c: v1.275:USB Universal Host Controller Interface driver
IPv6 v0.8 for NET4.0
IPv6 over IPv4 tunneling driver
Linux agpgart interface v0.99 (c) Jeff Hartmann
agpgart: Maximum main memory to use for agp memory: 431M
agpgart: Detected an Intel 830M Chipset.
agpgart: detected 8192K stolen memory.
agpgart: AGP aperture is 128M @ 0xe0000000
memory : c20eed60
eth0: no IPv6 routers present
e100: eth0 NIC Link is Up 100 Mbps Full duplex